http://www.seatcoverset.com/seatcovers-car_seat_cover.htm
In order to replace the driver side seat belt on a '96 Explorer, you must completely remove the drivers seat. Removing driver side seat belt: Use a 10mm socket/wrench to remove the two bolts securing the front of the seat to the floor. Move the seat as close to the steering wheel as possible to expose the rear of the sliding seat rails. Pop off the two covers at the end of each rail to expose two more 10mm bolts securing the seat to the floor. Next, remove the plastic cover with a Torx symbol on it at the rear of the seat belt guide rail. Removing the aforementioned cover will allow access to a large Torx bolt just below the rear of the center console. Remove this large Torx bolt, unplug any electrical wires below the seat, and remove the entire seat from the Explorer. With the seat out, you can use the same Torx wrench to unscrew the seat belt itself from the seat. Reassembly is the opposite of disassembly.
Sometimes you have to take the seats out to get to it.
It is usually a Torx bit. It been a while since I have done it so I cant remember the size. I do remember it was a larger size. Good luck.
try under the front passenger seat
Simply fastening your seat belt should put the light out. If you have a heavy object sitting on the passenger side seat like a tool box or such that could trick the light to come on. If not you have something disconnected or broken.
here you go try going here first www.ebookspdf.com/automotives/3189/ford-escape-2001-owners-manual/and if that doesnt work try what i did get in like ur going somewhere without ur seat belt on put ur key in to the on position but dont turn it on wait till the seat belt light goes off then pull ur seat belt in and out 3 times then real fast turn ur light on then off then real fast pull ur seat belt in and out again 3 times then in 5 sec. pull it back in and out then the seat belt light should flash 4 times or so if u done it right hope this help.
At the base of the pillar behind the door. One for each side. You have to remove the plastic trim.
My 2003 Ford Explorer mid seat retractable seat belt doesn't retrack,how do i fix it?
How do I remove the female seat belt assembly on a 97 ford exploer?
Wear your seat belt.
Buckle up.
Replace the belt and buckle as one unit.
how to fix seat belt
The computer module for the keyless entry system on the 2006 Ford Explorer is behind the rear passenger seat. It is located under the seat belt panel.
T50 or T55
The security module on 2002 Ford Explorer is on the passenger side, second row behind the seat belt panel.
In my 1995 Ford Explorer XLT ( 4 door ) with 2 rows of seating : 38.1 inches at belt with rear seat up 73.3 inches at belt with rear seat down according to my brochure
My 1995 Ford Explorer has seat belts for ( 5 ) If you have a 2002 or newer Ford Explorer with the optional third row seat ( 7 )
call car talk! 1 888 227 8255