answersLogoWhite
Pontiac Grand Prix
Grand Prix GT
Grand Prix SE

How do you reprogram the keyless entry for a 2002 Pontiac grand prix?

242526

Top Answer
User Avatar
Wiki User
2007-11-06 20:19:30
2007-11-06 20:19:30

You go to the dealership. Take proof of car ownership(registration) and proof of ID (Drivers license) it doesn't cost that much and it can be done there at the dealership in just a few minutes. Answer 2 You may just need to reprogram your keyless keyfob or replace the battery.

Follow the link below to reprogram. Hope this helps. "G"

1

Related Questions

User Avatar

You cannot reprogram it. A dealer can get you the Master Code if you've lost it.

User Avatar

All After 1996 require the use of the Chrysler scan tool.

User Avatar

Open the keyless remote and you will see the battery take it out and replace it with the same size.

User Avatar

how do you program a keyless entry remote to a 2000 Pontiac grandprix programyourremote.com (program your remote.com)

User Avatar

The dealers scan too can erase all remotes and reprogram any that you still have.

User Avatar

The receiver is behind the left side of the IP, behind the driver info center

User Avatar

If it's the original transmitter and it has gone out of sync with the vehicle, hold down both the unlock and lock buttons until the car horn honks. This should re-sync. If it's a replacement transmitter, I think the dealer will have to program it.

User Avatar

YOU CAN FINE ALMOST ANY KEYLESS ENTRY ON EBAY AND FOR A GOOD PRICE.. GOOD LUCK.........

User Avatar

I had the same problem. Google "keyless entry remote 2003 Jeep Grand Cherokee".

User Avatar

Look on the trunk lid support arm.

User Avatar

The keyless entry system must be programmed with an OBD II tool which the dealer or locksmith has. Sorry that this is not the answer your looking for, I didn't want to hear it either.

User Avatar

read the owner manual. It easy to reinitialize.

User Avatar

There should be a sticker on the underside of the trunk lid - that's where it was on my 92 grand marquis

User Avatar

The detailed directions are in your owner's manual. It is quite simple to do.

User Avatar

bring it to a dealer or a shop that puts them in you need a special computer and codes

User Avatar

this is all I got ..programming 93 Jeep keyless fobThis works for the Grand Cherokee:Sit inside the vehicle with all the doors closed.Place ignition in the OFF position.Open the driver's door. Leave Open.Move the mechanical door lever to the LOCK position.Turn the ignition to the RUN position.Aim the transmitter at the Keyless Entry receiver and press Lock button.Hold for five seconds until the door locks cycle.Turn ignition OFF within 20 seconds.

User Avatar

take it to a dealership and have them hook it to the computer. it's the only way I know of.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.