You can either try removing a 7.5amp fuse for about 10 seconds in the fuse box under the hood that says back-up on it. Alternatively, turn your car off. Press the oddometer reset button. While holding it, start the car half-way, and lights should start flashing. Keep holding for another 10 seconds or so, or until the lights will go out. Then, turn car off... wait a little while and turn it back on. This should reset the light, but it will come on if you still have a problem eventually. Enjoy.
To reset the check engine light on a 1998 Honda Civic located the blue 15 amp fuse in the engine bay fuse box. The fuse is labeled ECU, and will reset the check engine light when removed.
Check engine lights alert drivers of immediate need on any mechanical issues that need to be cared for. After issues have been cleared the check engine will need to be reset. To reset the check engine light in a 2002 Honda Civic simply unplug the battery for five seconds.
The check engine light on a 2004 Honda Civic can be reset by unplugging the ECU fuse in the engine bay fuse box. The ECU fuse is located is blue and rated at 15 amps.
To reset the check engine light on a 1994 Honda Civic locate the fuse box in the engine compartment. Find the ECU fuse and pull it off for at least 5 seconds. This will erase all codes on the ECU.
You reset the check engine light with a scan tool after repairing the failure.
The check engine light has to be reset with a OBD scan tool
have vehicle scanned to determine the problem and hae codes cleared
Have vehicle scanned to determine the problem and have codes cleared
disconnect battery and wait 10 sec reconnect battery
Check engine codes on Honda vehicles such as a 1992 Honda Civic have to be manually reset. To do so, remove the ECU fuse located inside the engine bay.
on most vehicles if you disconnect the battery cables it will reset the check engine light
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
The check engine light can be reset two ways. 1) If the problem resolves itself, the check engine light will reset itself after a certain amount of cold starts of the car on the on board computer system. 2) You need an OBD reader that has the reset check engine light capability.
As on all cars, you need an ECM scanning tool to reset the stored codes in the computer to turn off the check engine light. Many auto part stores will do this for free.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
Reset the Check Engine Light by disconnecting the battery for about 10 minutes.
It is important to make sure the check engine light is not on when having a car inspected. A person can reset the check engine light by clearing the codes that are causing the light to go on.
how do you reset check engine light in 2008 buick lucerne
How do you reset engine light on jeep liberty diesel