Check Engine Light
Mitsubishi Galant
Mitsubishi Trucks

How do you reset after having replaced the part the egr dashboard light from your 1987 mitsu mighty max pickup?

252627

Top Answer
User Avatar
Wiki User
2005-12-19 18:41:35
2005-12-19 18:41:35

Most are located behind the gauge cluster. You have to remove the trim and four screws to get to the little switch either by the spedo cable or lower right corner of the cluster. ( if this a 120,000 mile interval, remove the light!) REMOVE TRIM COVER FROM RIGHT LOWER DASH, YOU WILL SEE A SMALL SWITCH. USING A LONG SCREWDRIVER YOU CAN MOVE SWITCH AND RESET EGR LIGHT.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I'm no mechanic, but from what I have read, the later model engines have hydraulic lash adjusters that can be tested and replaced(Haynes manual).

User Avatar

Usually passenger side, under the dashboard.

User Avatar

Inside the dashboard, to the right of the glove box.

User Avatar

The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.

User Avatar

On the bottom side of the dashboard, in close proximity to the steering column,

User Avatar

Do you mean the expansion valve for the A/C? That is near the evaporator under the dashboard.

User Avatar

i have a 67 gmc 910 pickup. the choke in mine is on the dashboard above the steering wheel and to the right. it is a white plastic knob with the letter "C" on it.

User Avatar

no, the bearing usally go out on them. i just replaced the 1 on mine.

User Avatar

The 1986 Toyota pickup flasher relay switch is located beneath the dashboard on the drivers side of the passenger compartment. The flasher relay switch will be labeled as such.

User Avatar

when my 89 mighty max did this I had to push the tailgate in while I opened the handle. Once open adjust or graphite the connections

User Avatar

Remove the dashboard faceplate, and the rest is pretty simple.

User Avatar

if taking good care of it could get around 250000 miles,i had an 1987 mistubishi mighty max pickup wit 259000 miles

User Avatar

To the left of the ash tray, near the heater controls, under the dashboard.

User Avatar

Big job. I would suggest purchasing a shop manual to help guide you.

User Avatar

The 1986 Ford F1 50 pickup truck dashboard is held in place with six retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.

User Avatar

there is screws up along the bottom of the dashboard by the floorboard and then you have to remove the screws that hold in the cup holders and ash tray if you have any other questions my e-mail is redneck_308@hotmail.com

User Avatar

The benefits of having a turbocharger pickup is that it overall increases the efficiency of your automobile. The reason for having turbochargers is because they are usually used on small engines to take the place a larger one.

User Avatar

The Chevrolet K1500 pickup truck flasher relay switch can be found beneath the drivers side dashboard. The flasher relay switch will be above the brake pedal.

User Avatar

The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.

User Avatar

Ive been told Toyota corolla and a ford pickup


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.