THIS VEHICLE THROWS A CODE WHEN ELECTRONIC WEAR SENSOR HITS ROTOR, CAUSING MESSAGE "CHECK BRAKE LINING", AND BRAKE LIGHT TO COME ON. THIS CODE MUST BE CLEARED IN VEHICLES COMPUTER BY OBD II OR EQUIV.
HOW DO I RESET THE PAD WARNING LIGHT ON MY RANGE ROVER
Brake pads need to be replaced
To the right of the heat/air levers
range rover supercharge service light off
Coolning level
reset service engine light
its the brake switch censer under the brake peddle itself.
Take it to the Land Rover dealer or any rv dealer
Open the front passenger door and the fuse panel is in the side of the passenger seat.
Probably cause by a worn out/defective brake light switch.
Put the key in. Turn it to position two.(where all the dash board lights come on, dont start the car) Leave the key in that position for 45 seconds. The fault should clear provided your sensor circuits are complete.
Must be done by the dealers diagnostic machine