turn key to on. press gas pedal three times. turn off key. this resets light. turn key to on. press gas pedal three times. turn off key. this resets light.
Replace brake light switch.
Brake light on and why
Check the brake light switch. It is defective or out of adjustment.
looking for help on the brake light ground wire location for 1999 gmc suburban 4x4
With an OBD2 scan tool.
brake and abs light on , on 1994 Chevy Cavalier Z24
the brake light switch is on the top of the brake pedal arm. under dash.
The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.
Recommend checking the operation of the switch that is actuated by the brake pedal itself. This switch is either mounted to the brake pedal or mounted under the dash and actuated by the movement of the pedal
Have you checked the brake fluid level in your brake master cylinder in your engine compartment ? a low level will turn on your brake light in the dash
Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.
1994 Chevrolet Suburban brake light bulb lamp replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
when this light is on it means that there is something wrong with your anti-lock-brake system and you should go get it checked.
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
The 1999 Chevrolet Malibu brake light switch can be found beneath the dashboard, next to the brake pedal. The brake light switch simply plugs in and out.
A brake fluid leak in the brake system, LOW BRAKE FLUID.
It is on a bracket under the dash and above the brake pedal.
Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.
The brake light switch is under the dash, and whenever the brake pedal is touched the brake light comes on. If the switch has failed or is out of adjustment it will leave the brake light on.
If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.
Low brake fluid in master cylinder? Parking brake not fully released?
On the inside of the cargo area look to where the backside of the light would be. There will be 2 phillip's head screws. Remove those then there are 2 tabs as well, press on the tabs and the light housing will fall out. Then you willbe able to twist the light bulb and remove it. Installation is the reverse.
Under the instrument panel..Its a 15 amp one...
under the hood in black box