Unhook the positive post to the battery for approx 10 minutes. That SHOULD take care of it IF the problem that triggered the light is fixed.
A check engine light means you have a possible problem with the emission system , you should get the Ranger scanned for trouble codes to diagnose and repair the problem . Once the problem has been repaired the check engine light can be reset.
Disconnect the negative battery cable for 30 minutes.
If the check engine light is on, there's something wrong with the engine. Or, the computer is bad. One or the other. They don't set a light for no reason.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
Should be able to reset it by disconnecting the negative battery cable from the battery for ten minutes.
You reset the check engine light with a scan tool after repairing the failure.
The check engine light has to be reset with a OBD scan tool
No there is not a reset button. You can try disconnecting the negative battery cable for 5 minutes and that may reset the check engine light. If not it will have to be reset with an OBD2 scanner. Remember if you do not repair the problem that caused the light to come on you are wasting your time resetting it as it will just come back on.
Take it to Autozone (or your local parts store) and they will connect the scan tool to your truck, then you will press reset.
how do i reset the check engine light on a 1999 acura 3.2tl
on most vehicles if you disconnect the battery cables it will reset the check engine light
hoe do you reset the check engine light in a 1995 land rover
The check engine light is illuminated for a reason. One of the engine control devices has probably ceased functioning. Take the vehicle to a shop for diagnosis, and repair of the problem.
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
The check engine light can be reset two ways. 1) If the problem resolves itself, the check engine light will reset itself after a certain amount of cold starts of the car on the on board computer system. 2) You need an OBD reader that has the reset check engine light capability.
Unplug the ecu . . . which, when looking into the engine, should be on the leftside firewall. Single bolt holding the plug into it.
how do you reset check engine light in 2008 buick lucerne
How do you reset engine light on jeep liberty diesel
Reset the Check Engine Light by disconnecting the battery for about 10 minutes.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
It is important to make sure the check engine light is not on when having a car inspected. A person can reset the check engine light by clearing the codes that are causing the light to go on.
To reset the check engine light on a 1998 Honda Civic located the blue 15 amp fuse in the engine bay fuse box. The fuse is labeled ECU, and will reset the check engine light when removed.