push the button down
On a 1994 Ford Ranger : Check in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump I believe that is where the fuel pump inertia switch is on a 1994 Ford Explorer
The 1994 Ford Ranger pickup truck turn signal switch can be found below the dashboard. The switch will be on the drivers side. The turn signal switch should be labeled as such.
It's located under the instrument panel to the right of the transmission hump, behind the carpet or vinyl. I had to reset it on my 93 ranger but its still in the same location as a 94 ranger. Hope this helped
On my 1995 Ford Explorer if the switch has been tripped so that no power is going to the electric fuel pump , the fuel reset light comes on in the gauge cluster in the dash
where is the fuel reset button on a 1994 ford ranger Driver side trunk. behind plastic covering
The fuel pump shut off ( inertia switch ) is located in the front passenger footwell behind the kick panel on a 1999 Ford Ranger
On a 1994 Ford Ranger : Check in the front passenger foot well , under the front edge of the carpet , mounted on the toe board , just to the right of the transmission hump On a 1994 Ford EXPLORER , I believe that is where the fuel pump shut off switch ( inertia switch ) is
Because it had tripped for whatever reason.
On a 1994 Ford Ranger : Check in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump ( that's where the fuel pump shut off switch / inertia switch was on my 1993 Ford EXPLORER )
The switch is under the right side of the glovebox , above the carpet ( according to the owners manual for the 2004 Ford Ranger )
I BELIEVE the fuel pump shut off switch / inertia switch is in the front passenger footwell , under the front edge of the carpet , mounted on the toe board , just to the right of the transmission hump on a 1994 Ford Ranger
If you are talking about the emergency fuel shut-off switch (aka inertia switch). just push in the button on top of the switch.