answersLogoWhite
Oldsmobile Ninety-Eight
Ford Expedition Eddie Bauer
Ford Expedition XLT
Ford Explorer Limited

How do you reset oil change light on 1992 olds 98?

525354

Top Answer
User Avatar
Wiki User
2006-01-04 04:28:57
2006-01-04 04:28:57

press the oil button then press the reset button hold for five seconds it will reset oil life monitor back to 100%

1

Related Questions

User Avatar

for a 1997 olds aurora you have to press the engine "eng" button till you get to the "change oil now" then press and hold the reset button till it says "oil life 100%". it should be the same for a 96.

User Avatar

The light is reset with a scan tool after the repair. There is not a button.

User Avatar

how do i change the starter on a 1997 olds 88 royale?

User Avatar

how to get the check oil light to go off on a 2001 olds alero

User Avatar

I have a 2000 Olds Silohuette. I just reset the "Change Oil" light by turning the ignition to on(DO NOT START THE VEHICLE), pushing the accelerator down to the floor 6 times, turning the ignition off, and then starting the van. The light did not come on. Hopefully this will help.

User Avatar

yes, it does! its located on the back fender below the light!

User Avatar

hold in reset button until it flashes then press once more, it is located in the fuse box , open driver side door and fuse box panel is located on the left side of dash board

User Avatar

you cant bad speed senser in one of the wheel bearings is abs light on?

User Avatar

Have vehicle scanned to determine the problem usually in the emission control system

User Avatar

Eventually. Sometimes it takes 3 drive cycles or more.

User Avatar

Disconnect the battery, wait 10 minutes, and reconnect.

User Avatar

Either try disconnecting the battery for about 10 mins. or have vehicle scanned to determine the problem

User Avatar

You'll need to find a shop with a code reader that reads ABS computer codes.

User Avatar

Gm does not use inertia/reset switches.

User Avatar

You must drop the fuel tank to access the fuel pump.

User Avatar

Look at my answer for the question posted directly above this one.

User Avatar

Gm vehicles do not use inertia/reset switches.

User Avatar

To reset the security light on an Oldsmobile vehicle, first the driver must turn the key to the "on" position, without starting the engine. Next, he or she should turn the key to attempt to start the engine, but not completely, so that it doesn't start before moving the key back to the "on" position. After about 12 minutes, the light will?æbe reset, and the key should be removed.?æ

User Avatar

How do you change a cradle mount for a 1995 OLDS 98

User Avatar

I do not know specifically for your vehicle, however I had the same thing on my 1998 Olds Intrigue. The mechanic turned the key to the on position, then pressed down on the accelerator three times. That reset my sensor.

User Avatar

Change what?Change what?

User Avatar

Gm vehicles do not use inertia/reset switches.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.