Hey Carol==Press the trip/oil reset button on the dash for about 12 seconds. When the light flashes, it is reset. GoodluckJoe
turn on and off the igition switch three time's at third time leave no this should do it.
If you turn the ignition to the on position and tap the gas three times quickly it should turn the light off.
you will need a scan tool to determine the cause and to reset
how do i reset the check engine light on a 1999 acura 3.2tl
Resetting the maintenance light on a 1999 Toyota Tacoma is very easy to do. To reset the light, take the battery cables off for up to one minute to reset the light.
there is no "reset" new pad and sensors is the fix if you have had this done they botched the job
How to reset maintenace light on 1999 acura t l 3.2
There is nothing to "reset" for the 1999 VW Beetle.
You can find that info in your drivers manual.
how do I reset my service engine light on my 1999 ford f150
Try this. Push and hold the odometer trip reset button while turning on the ignition but not starting the engine. Hold it for 5 seconds. This should reset the light.
The check engine light has to be reset with a OBD scan tool
There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.
After repairing the cause of the code, you reset with a scantool.
Carefully!!! You will need to pressure bleed the system and it will require a scanner to reset the light.
key on engine off press accelerator pedal to the floor five times very rapidly should reset
turn the key in the on position without starting it and press down on the gas pedal three times and the change oil light should start blinking
The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.
go right underneath the light and there should be a panel where 2 or 3 screws are take those off and u should be able to get to the light bulb, you have to twist holder which the lightbulb is in
After the repair, you reset it with an OBD2 scan tool.
check engine light reset on a 1999 acura cl 3.0.. Just replaced the egr valve. Thx
you will probably need to open the trunk, remove corner of carpet behind the light along with any plastic or metal being the taillight. then there should be a little pannel you can take off to get access to the light.
The easiest way to reset the timing belt light, on your 1999 Toyota, is to remove the dashboard light. Keep the fuse out for 10 seconds and replace it to that slot.
Repair the problem and then reset it with an OBD2 scan tool.
are you sure it's check gauges light or could it be check engine soon? Reason I'm asking is because I just recently purchased 2001 firebird, and check gauges light came, it just needed gas. Then it came on again to change oil. So I changed oil and it went off.
After the Explorer is scanned for trouble codes to diagnose and then repair the malfunction , then the check engine light can be reset
Try going to autozone they check the engine light signals for free and have reset mine