0
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you reset the service ccr system on the driver information center on a 1991 Cadillac eldorado?
What is needed when the ccr is driver information center
How do you reset the change oil light on a 1991 Eldorado?
To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds
How do you Reset SRS light for 1991 Eldorado Biaritz Cadillac?
You can't. The SRS light is on because the SRS (Supplemental Restraint System) has detected a fault in the system. Until it is fixed the light will remain on and the SRS will not function if needed. Once the necessary repairs are done the SRS system will reset the light itself.
How do you reset engine Light on 1991 Volvo 240 DL?
how do you reset engine light on 1991 volvo 240
How do you reset service engine soon light on 1991 Pontiac Bonneville?
remove battery cable for 1 min
How do you reset the brakelamp light on the dashboard - Honda prelude 1991?
reset the brakelamp light on the dashboard - Honda prelude 1991
How do you reset a service engine soon light on a 1991 buick regal?
Disconnect the negative battery cable for 10 seconds.
How do you reset service engine light on 1991 olds 88?
Have vehicle scanned to determine the problem usually in the emission control system
How do you reset a 1991 service engine light for a Oldsmobile 1991?
Disconnect the negative battery cable from the battery, wait a few minutes then reconnect it. But, if the reason the light came on isn't fixed, the light will only come back on again.
How do you reset the check engine light on a 1991 Mercedes Benz 560 sec?
How do you reset the check engine light on a 1991 mercedes Benz 560 Sel
When was Eldorado Gold created?
Eldorado Gold was created in 1991.
How do you reset the oil service warning light manually on a 1991 BMW 520i?
You have to use the tool. A dealer will most likely have to do it for you. Unless you just have one laying around.
