the light will reset itself when the problem is fixed, therefore the problem has not been fixed. take it back!
As an alternative to waiting for the system to decide the problem is fixed you could plug an OBD II reader into the port under the dash. The reader can be used to turn warning lights off and reset the system. Note, as mentioned above, if the problem isn't really fixed the light will come on again.
the knock sensor cuts the engine out so it won't damage the car if not replaced, the car just won't work.
Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.
If someone could please explain who to get to the oxygen sensor and explain where it is for sure?
No but if you do it wrong (oily filter or leaky connection) you can damage the sensor while driving making it necessary to replace that sensor later.
can anyone help me please Its the sensor directly under the intercooler remove the intercooler and a couple of airpipes and you will get at it easiar.
It requires a special socket with one side cut out so as not to damage the wiring.
To replace the crank sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws
Depends on which engine you have. More info please.
I think you could. The vehicle speed sensor is next to the oil filter on a 1.8T engine, manual transmission. You could pull on the sensor cable while rotating the filter, and possibly damage the sensor. It's fairly easy to replace. Sensor cost is $20-50.
Without knowing what sensors you are trying to replace, there is no answer. Please re ask question about a specific sensor.
Because he is samir
Ummm, because it doesn't work anymore?
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
where is the oil presure sensor on a 2006 chevy impala lx 3.5 v6 and how do i replace it pics or video please thanks
You can not replace just the tire pressure sensor on a Boxster. You will need to replace the whole sensor. The sensor is located inside the tire assembly.
same way you replace any sensor.
Probably not, but it will certainly cost in fuel, performance and excessive emissions.
Should be the rearmost O2 sensor in bank 2. Use a wrench or O2 sensor socket to get it out. Unplug it first from the harness so it doesn't get all twisted and damage the plug on the car's harness.
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
That will depend greatly on the vehicle. Please ask a new question and include year, make, and model.
No, you have to replace the complete tank which includes the sensor.
How much will it cost to replace a cank sensor on a Mazada 626?
how to replace a map sensor on a 2004 dodge intrepid.
how do you replace coolant temp sensor on a rodeo
Most engines have the temperature sensor either at the top water inlet or on the side of the block. Remove the sensor wiring, then unscrew the sensor to replace it.