Press the unlock tab for the driver's side door. Insert the key in the ignition and cycle the switch from off to run 8 times quickly. On the eight cycle, with the key in the run position, press any button on your keyless remote. Wait until the locks are done cycling and release the remote. Switch the ignition off and wait for one last click. The anti-theft will be reset.
Turn the ignition switch into the "On" position and leave for approximately 30 minutes. The security light will remain flashing for approx. 10-15 minutes. Then, will turn off and the modulator will reset. Then, turn the ignition to the off position take the keys out and the reinsert and start the car. The "security" light at this point will be off. Due to the security modular, the fuel pump is being shut off to control the theft of the car.
Check owner's manual. If you don't have one copy and paste link below; www.fleet.Ford.com/maintenance/owners_manuals
my 2002 Mercury Sable won't start, i think the anti theft device was activated by accident, how do I deactive so i can get my car started?
how do you reset computer on a 2003 ford explorer after oil changes
Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)
dealer does it, or use key fob
.You can reset the antitheft system, on your 2003 Chevrolet Cavalier, by removing the fuse. Keep the fuse out for 10 seconds. Replace the fuse to its original slot
disconnect battery for 30 minutes,and then reconnect to reset
disconnect battery for 30 minutes,and then reconnect to reset
In the right front passenger footwell , by the kick panel
You can reset your antitheft system by removing the antitheft fuse. Keep the fuse out for 10 seconds. Replace the fuse to its original slot.
You will have to do a full global reset. To do this, disconnect both of the battery cables for 5 minutes and then tape or hold them together while they are disconnected for another 2 minutes. Reconnect everything and it will be reset.
Each vehicle with keyless entry has it's own factory code
should be a card in the owners manual with a 4 or 5 numbers on it enter into radio and away you go .
in the internal fuse box on the back unplug the cables that go into the board. REMEMBER TO MARK WHAT GOES WHERE.