With key on, radio off, hold down the top button on the radio. The screen will change, then use the seek button till oil life comes up. when it does hit the dis, button again, it should say reset.
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
How do you take a rheostat out of a 2003 monte carlo
i have a 2004 chevy monte carlo and the service engine soon light is on what does it mean?
Brake light switch on the brake pedal is defective
Cant Must replace entire radio
To replace fog light bulb of Monte Carlo you must remove the entire assembly. Replace the bulb that has been hindered and replace the assembly.
you have to take off the dash cover witch has 5.5 size screws
No it does not, atleast not the 97 SS
check your break fluid.
It should be in the fusebox with the rest of the fuses.
get the computer scanned to find out what the problem is.
Very possible a door switch is defective.
the wiring is probally defected or the light is burned out
This is the light for your security system. Shows that it is working.
The tool required to pinpoint diagnose the ABS issues in the 1995 Monte Carlo Z34 is a $4000 diagnostic tool. The garage will charge you $100 for the scan.
Jack the frontend of the car up and crawl under it and pull the piece of plastic down out of the way that is in back of the light and you will then see the light to be able to change the bulb or take the complete light assembly out if you wish.
have vehicle scanned to determine the problem
instrument cluster is shorted out or corroded
Did you change the radiator? If you did you might have the wrong one,without a full provission for the sensor. If you did not the plug might be disconnected or faulty.
I also have a 1997 Monte Carlo LS 3.1 and I've had the same problem. It was the alternator.
Dead or weak battery? Alternator not charging battery properly?
You probabl need an alignment-
no, just one solid one, also used as the blinker.
if the headlights work it is bad wiring if they dont its a fuse
take the cover off and there is two screws, take them out and that's it