The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.
You have a problem with the brake system. Once you repair the problem the light will reset itself.
Cadillac does not use inertia/reset switches.
How to reset the theft system on 1997 Cadillac Seville
how do i reset theft problem for 96 caddilac deville concours
there is no fuel reset as in a ford.
A person can reset the air ride suspension on a Cadillac Deville by disconnecting the compressor wiring harness from the compressor itself. This is accomplished by putting the vehicle on ramps.
Press and hold the reset button on dash
Press Information until you get to OIL Message. Then Press and hold for 3-4 seconds and it will clear back to 100%
Have vehicle scanned to determine the problem - usually a problem in the emission control system
It does not have one.
It is equipped with no such button.
disconnet the negetiv to the batt for 60 sec then reconnect. it should be reset .
there is no fuel pump reset switch on this car.
2000 Cadillac Seville SLS Anti-Theft System how do i reset it
Disconnect the battery for a few minutes, then reconnect it.
In the trunk or passenger compartment
You do not reset a master cylinder. You should bench bleed it before installing.
GM vehicles do not use inertia/reset switches.
Hit INFORMATION button until oil percentage is displayed. Press and hold reset until display reads 100%
If you unhook the battery for an hour, when you re-connect the cable it should reset the computer.
Put IGN in the ON position, ENGINE NOT RUNNING. Push the acceleration pedal up and COMPLETELY within 5 SECONDS. This should re-cycle the OIL LIFE and only show the light upon starting.
unhook your battery for about 1 min and hook it back up
reset battery no charge light after battery replacement.
You can reset your 1999 Cadillac Deville air conditioning control by removing the air conditioning control fuse. Keep the fuse out for 10 seconds and then replace it to its original position.