Chevy Silverado
Ford Expedition Eddie Bauer
Ford Expedition XLT

How do you reset the change oil light on a 1998 Chevy Silverado extended cab?

737475

Top Answer
User Avatar
Wiki User
2015-07-16 18:30:43
2015-07-16 18:30:43

hi there you can reset the oil light by turning the key on and engine off, and fully press the gas pedal 3 times in 5 seconds then start the truck and the oil light should flash, if it dont work try it all over again or look in your owners manual under reset oil light.

instead of turning on ignition and pressing gas pedal three times try turning on ignition and pressing the brake pedal three times it worked on my 2001 silverado !

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

what does it mean if my brake light is blinking on and off when its pushed down in my 1999 Chevy silverado

User Avatar

take the old ones out and put new ones in!

User Avatar

a 2003 Chevy silverado taillight bulb uses a 3157

User Avatar

If you mean a low fuel light, then NO.

User Avatar

It should if it is the round body style such as 2001 or 2002.

User Avatar

You can't you have to replace the whole dashboard instrument cluster assy.

User Avatar

Most likely the fuse is blown for the dome light on the Silverado if the light doesn't come on.

User Avatar

A Silverado C1500 is a 2WD light truck, K1500 is a 4WD light truck. Please clarify what you mean about the r and the v as I am unfamiliar with that coding.

User Avatar

problem with the abs, get it fixed

User Avatar

take the metal trim piece out from around the light with the torques bit and the light should pop out, just unplug it and install new light.

User Avatar

Borrowed from silverado answer: Push the set button and with the set light on, press either the scan or seek buttons to change...

User Avatar

The signal light flasher on a 1992 Chevy Silverado is under the dash. It is on the driver's side just above the brake pedal.

User Avatar

remve the tail light they are on the back side.

User Avatar

The first Silverado Chevy was released in 1998 and it was a light pickup truck model named GMT800 Silverado. Prior to this, the term "Silverado" was used by General Motors to refer to the trim for the Chevrolet C/K pickup trucks.

User Avatar

There are a couple of reasons a 1999 Chevy Silverado third brake light will not work. The first may be that the light bulb is burnt out. If replacing the bulb does not work, there may be loose wires to the connection causing it to not work.

User Avatar

How do change a light on a steering column in a 2006 chevy truck?

User Avatar

on a 2002 Chevy silverado with a 4.6 liter v6 where is the coolant sensor for low coolant. I have a light on and check the overflow and their is coolant but don't know if their is another one or not.

User Avatar

In the power distribution box under the hood.

User Avatar

Think it's on the brake pedal close to the top

User Avatar

how to change brake light switch in a 2007 chevy colorado

User Avatar

key on engine off press accelerator pedal to the floor five times very rapidly should reset


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.