Have vehicle scanned to have stored codes erased
where is the fuel pump reset button or relay switch located on a gmc sierra 2003 and how do i get to it?
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.
There is none.
no you wait till you it changed
How do I reset the service engine light on a 2003 Chevy Trailblazer?
reset service engine light
How do you reset service light in 2003honda pilot
AnswerTo reset the change oil soon light turn the key to on (not run) and step on the gas to the floor 3 times fast.ACCORDING TO THE 2003 OWNERS MANUAL1. With Key on, (a short time after turning off the engine), press reset button located on drivers side instrument panel fuse block . Button is located at top.2. When the change oil light starts to flash, press and hold the reset button again3. The reset is complete when you hear the chimes and the CHANGE OIL light goes out
Reset light when replacing headlight
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.
How do you reset the oil service warning light manually on a 2003 BMW 525i?
You need a scan tool to reset light after repairing the code.
= How do you reset the Airbag light on a 2001 Nissan Maxima SE ? =
turn the key to the on position engine not running step on gas pedal to the floor three times and wait for light to flash and go out and its reset
Type your answer here... Hello how do you reset the check engine light on a 2003 Toyota 4runner. Thanks
Listed in your owner's manual. However, the reset pushbutton performs two functions. The first function is to find or select the change oil light. The second function is to reset the change oil light. So, when the manual says press the reset pushbutton, it means to press and release, press and release, press and release, ... and so on.... until the change oil light is selected. The change oil light is selected when it begins to flash on and off. Once the change oil light is selected by it flashing on and off, press and hold the reset pushbutton again in solidly to actually reset the light. Hold the reset pushbutton in until the chimes sound. This confirms the change oil light is reset and the light should go out.*Remember* before you even begin resetting using the reset button, the car must be in neutral or park or it will not work.AnswerIf you do not have an oil change reset button located on the drivers side inside the fuse panel. Turn ignition key to the on position (with engine off). Depress accelerator pedal 3 times. Oil change light should blink and you should here a beep, light will go out. Turn ignition key off.
reset service engine light on BMW 325
When the Mini cooper 2003 airbag light is permanently on, then it needs to be reset.
To reset a check engine light for a Highlander 2003, disconnect the battery for 10 minutes. After this time, reconnect the cables.
To reset "MAINTENANCE REQUIRED" light, turn ignition off, press and hold the SELECT and RESET buttons. Turn ignition and hold buttons for 10 seconds until the indicator resets. works on 2003 mdx for sure.
what causes the light to come on
Listed in detail in your owner's manual. Don't have one then you need to get one.
You have a problem with the brake system. Once you repair the problem the light will reset itself.