Pull the codes from the computer, match the code to the troubleshooting procedure, follow the procedure to find the source. Repair the source, light will go out if that was the only problem. There are "monitors" or self test the computer runs the car through, if a problem occurs, it may not run all of the self tests until that problem is taken care. Therefore, another problem may exist. It is emission related.
how do you reset the tension on a 1999 Chevy cavalier 2.4 litre
what does a bcm in a 2000 cavalier control
Chevy does not use inertia/reset switches.
The service light indicator on a 2004 Chevy Cavalier tells its owners when to send the vehicle in for maintenance. To reset the light, unplug the battery for five seconds.
disconnet theft sistem on Chevy cavalier? Sorry....you really can't. You have to reset it.
disconnect the battery for a couple minutes or use a code reader to reset them.
Gm does not use inertia/reset switches.
Chevrolet does not use inertia/reset switches.
how do reset a 1998 chevey cavalier antitheft system if it want start and the anti theft light is on
The 1987 Chevy Cavalier has airbags. Many of these were recalled due to an airbag defect. When returned to the dealer, the air bag sensors had to be reset.
Put your Chevy Cavalier in neutral and then crank it once without starting the car. This will turn on the electrical system and you need to allow it to sit like that for several minutes for everything to reset itself.
from what i have been told that you disconnect the battery terminals and then reconnect them. that should reset the computer
disconeect the battery for a few minutes that will reset the computer and remove the service light signal
Chevrolet does not use inertia/reset swtichesChevrolet does not use inertia/reset swtiches
Chevrolet vehicles do not have inertia/reset switches.Chevrolet vehicles do not have inertia/reset switches.
It will be to the left of the thermostat housing, in the intake.
Un plug the BATTERY FOR 10 OR 15 MINUTES. I mean unplug BOTH the battery contacts, and plug them back this will RESET ALL the faults
Have vehicle scanned to determine the problem and have codes cleared
There is no reset for the computer. You can disconnect the negative battery cable for 5 minutes and this may or may not reset any fault codes. If not they will have to be reset with an OBD2 scan tool.
Take off the + on battery for 10 sec that should clear the code.
disconnect the negative battery cable for 30 seconds and hook it back up.
if you are looking to reset a check engine light or any trouble codes, you will need to have it done with an OBD2 handheld scanner.
Have vehicle scanned to determine problem and have codes cleared