Ford Expedition Eddie Bauer
Ford Expedition XLT
Ford Explorer Eddie Bauer

How do you reset the compass on a 1998 Ford Expedition Eddie Bauer?

596061

Top Answer
User Avatar
Wiki User
2006-04-02 18:29:23
2006-04-02 18:29:23

There is a small hole on the underneath side of the rearview mirror. You have to use a paperclip to push the reset button inside and turn the vehicle in slow, short circles until it resets.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

i have a 98 ford expedition xlt the remote does not work how do i reset the alarm so it will work

User Avatar

My Explorer won't turn over; the lights come on and attempted to jump the vehicle. Where is the fuel bottom if engine does not turn over?

User Avatar

In the front passenger footwell by the kick panel

User Avatar

As far as I know , you inflate the tire(s) to the correct pressure and then drive the vehicle

User Avatar

Check your owners manual. If you don't have one copy & paste this link. http://www.genuineservice.com/genuineservice/en/gloveboxresults

User Avatar

how do you get the entry codes for expedition eddie bower

User Avatar

Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)

User Avatar

Auto Zone will read your codes FREE. They will tell you what is causing them to come on. This way you can fix your problem without having to guess. They will or can reset your codes if you ask them too.

User Avatar

In the right front passenger footwell , by the kick panel

User Avatar

To unhook a factory alarm system look for the alarm brain on the dash and Cut the two red and blue wires. Reconnect the wires and the alarm will be reset it self.

User Avatar

It should be on the keyless entry control module behind the fuse box (below steering column) on the firewall. It's a five digit number 1xxxx.

User Avatar

In the right front passenger footwell , by the kick panel

User Avatar

In the right front passengers footwell , by ( or behind ) the kick panel

User Avatar

Try disconnecting the battery. Let it sit for a few minutes and reconnect. This will reset your computer.

User Avatar

how to reset the computer on a 1997 ford expedition

User Avatar

1st. Push the compass and reset button at the same time. 2nd. Select "reset" to reset the compass. 3rd. Start driving slowly in a circle, until it resets.

User Avatar

Where is the reset button for the fuelpump on an expedition

User Avatar

Jeep vehicles do not have reset/kill switches.

User Avatar

How do I go about restting the mirror-based compass in a 02 nissan Altima?

User Avatar

after install a new compass in my chevy venture how to reset it?

User Avatar

According to the 2003 Ford Expedition owners manual : The fuel reset switch is in the cargo area , in the left rear , by the liftgate The switch is behind 2 access panels , the second panel has a tab that needs to be pushed down to remove the access panel door

User Avatar

I believe that is in the right front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump

User Avatar

There is a small hole below the compass button that allows for something small such as a paper clip... press and hold it and it will allow for you to configure the compass..


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.