DISCONNECT BATTRY FOR ABOUT 10 MIN
try removing the negative lead on the battery for about 30 min that will reset your computers
2002 Audi quattro 1.8 ignition module location
it should have the voltage regulator built into the alternator
The process of removing a 1998 Toyota Camry ignition switch requires taking apart the steering column and lower dash, as well as several of the under-dash relays. The ignition switch is connected to the key cylinder and cabin wire harness. A faulty ignition switch will prevent the car from starting.
Ebay, that's where I purchased mine.
How do rest anti theft
ignition timing is controlled by the electronic control module or the "brain" on distributorless engines. Reysher
A 1998 Ford Taurus uses the Electronic Distributorless Ignition System ( EDIS ) with a coil pack , so there is no distributor
All the engines used in a 1998 Ford Explorer have electronic ignition ( EDIS , Electronic Distributorless Ignition System ) The 4.0 liter EFI , V6 and the 4.0 liter SOHC , V6 use one coil pack for the six sparkplug wires The 5.0 liter , V8 engine uses two coil packs for the eight spark plug wires
No. If you car is having difficulty requiring reset, disconnect the battery overnight or for several hours. This will reset the computer and clear any codes that may cause the computer to prevent the ignition from operating. There are a couple of ignition codes that will prevent the car from starting.
A 1998 Lincoln Town Car has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils , so it doesn't have the " normal " spark plug cables
On a 1998 Lincoln Town Car : It has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils ( 1 ) coil for each spark plug
A supercharger, advance the ignition timing, reset the ECU, use high octane gas.
I'm not a mechanic / technician but the ( 1998 ) Lincoln Town Car , 4.6 V8 has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils
Drivers side in the trunk behind the little panel on the side
Resetting the maintenance light on a 1998 Odyssey is very easy to do. All you need to do is hold the reset button down and then turn the ignition on at the same time. The button will need to be held for 10 seconds.
You don't mention the engine size but it doesn't have a distributor It is either EDIS ( Electronic Distributorless Ignition System ) or Coil On Plug ( C.O.P. ) ignition system