To reset the oil light, put the key in the ignition and turn to accessory setting (but do not start the car) Push the English/Metric button twice and then push and hold the "Gauges" button. The "Change Oil" light will flash for about 15-20 seconds and then go out. Release the button and turn key off.
When you turn the key back on, the light should be out. If it is not, repeat the above steps.
== == how do you reset the oil light on a1992 corvette
go to your oil percentage then hit and hold reset button
oil servis reset without using a computer http://www.kofla.net/chevrolet.htm
Just changing the oil doesn't do anything to the gauge, hold reset button down until readout changes change the oil
after changing your oil, press the TRIP function by the steering wheel until oil life is displayed. It should be at 0%. Then hold the RESET button for a few seconds and it will clear it and put your oil life at 99%.
How do I reset the service engine light on a 2003 Chevy Trailblazer?
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
How do you reset check engine light for the 2009 Chevy trail blazer?
Turn the key to the Run position, but do not start the engine. Press and release the ENG MET on the trip monitor. Within five seconds, press and release it again. Within five seconds press and HOLD the GAUGES button on the trip monitor. The CHANGE OIL light will start to flash. Hold GAUGES botton until flashing stops. Light is now reset.
Reset the change oil light on Mazda 3
After an oil change, or when "CHANGE OIL" appears on the Trip Monitor, with the ignition on and engine off, press the "ENG MET" button (located on trip monitor) once. Press the "ENG MET" button again within 5 seconds. Within 5 seconds, press and hold the "RANGE" or "GAUGES" button (1990-1994). The light will flash. When it stops flashing and goes out, the system is reset.
When you take your car in for an oil change, have the technicians there do the reset for you. (they should automatically do that for you, but you may have to ask them....to make sure they do it) Valvoline does it as part of their service.
how do you reset change the oil light in a 2004 alero?
You can reset the light by disconnecting the battery for 10 minutes. It will come back on again if you do not correct the problem that set the light in the first place.
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
Turn the key to the 'on' position (do not start the truck).Wait for the change oil light to come on.Tap the gas pedal 5 times.Move key to off position, move key back to on position. The change oil light should be reset.
turn the key to the on position engine not running step on gas pedal to the floor three times and wait for light to flash and go out and its reset
The service light indicator on a 2004 Chevy Cavalier tells its owners when to send the vehicle in for maintenance. To reset the light, unplug the battery for five seconds.
disconnect the battery for five minutes, It will reset
The reset ranch light with the oil can on a Chevy C 5500 is a warning to check the oil. It can also mean that the oil needs to be changed.
key on engine off press accelerator pedal to the floor five times very rapidly should reset
The ABS light is on because there is a fault in the system. Once the fault is repaired or fixed the light will reset itself. The ABS system can be scanned for codes to help diagnose the problem.
Fix the cause of the light coming on and the light will reset itself within a few drive cycles.