Chevy Camaro
Chevy Silverado
Buick LeSabre
Oldsmobile Alero

How do you reset the security light on 1997 Camaro?

111213

Top Answer
User Avatar
Wiki User
2011-09-12 21:12:56
2011-09-12 21:12:56

unhook the negative cable from battery for 10 minutes. Hook negative back up and turn ignition key to on position. Leave on for atleast 20 minutes or until security light goes off.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

GM vehicles do not use inertia/reset switches

User Avatar

how to reset the oil light on a 1997 mercedes e420

User Avatar

do not start vehicle but turn key to on position then off three times and on that third time leave it on the "on" position takes 10 to 15 minutes to reset the security light should stop blinking.

User Avatar

how do I reset tne brake pad sensor light on a 1997 BMW 318i

User Avatar

No, GM does not use inertia/reset switches.No, GM does not use inertia/reset switches.

User Avatar

how do you reset change oil light on chrysler grand voyager minivan 1997

User Avatar

Repair the problem and it will reset.

User Avatar

It is very easy to reset a check engine light on a 1997. The light can be reset by putting the restet tool into the diagnostic port. The diagnostic port is located right beside the hood release latch.

User Avatar

The airbag light, on your 1997 Jetta, can be reset by removing the fuse. Keep the fuse out for 10 seconds. Replace the fuse back to its original position.

User Avatar

A person can reset the airbag light on 1997 Buick Regal by checking the wires and making sure they are all plugged in. Then by clearing the codes causing the light with an OBD scanner.

User Avatar

After repairing the failure that caused the code, the lights will reset themselves.

User Avatar

The low pressure light on a 1997 Pontiac Grand Prix is reset by bring the pressure in all tires back to normal. This will update the system and turn the light off.

User Avatar

To reset the service engine light on a 1997 Suzuki Sidekick first turn off the car. Unplug the battery of at least 5 seconds and then plug the battery. The computer will now be reset.

User Avatar

how do you turn off or reset the check fuel cap light on a 1997 Mazda b 2300 2.3 4 cylinder engine.

User Avatar

pull the bulb out on the gages. light should go off.

User Avatar

After reading the code, and repairing the codes, you reset code with a scan tool.

User Avatar

I believe that is a dealer only problem.

User Avatar

---- ====== ====== i briging quite back yea ---- ====== ====== i briging quite back yea

User Avatar

When the failure that set the code in the computer is repaired the light will clear itself.

User Avatar

Disconnect the battery overnight, or for several hours. If you have the stock stereo BE SURE you know the unlock code for it...read the manual.

User Avatar

The service engine or check engine light can be reset with a scan tool or by unhooking the battery. The light will return if the failure that caused the code is not repaired.

User Avatar

just remove the battery cable for about 5min then put it back. that should reset the check engine light.

User Avatar

push door open on remote, or unlock driver door with key.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.