Check Engine Light
Buick Century
Ford Explorer Sport Trac

How do you reset the service engine soon light after replacing the fuel pump in a 1990 Buick Century?

323334

Top Answer
User Avatar
Wiki User
2011-09-12 21:13:03
2011-09-12 21:13:03

Try disconnecting the positive battery cable for at least 15 min. If this doesn't work you will have to take it to the garage to have the computer reset with their machine.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the lowside service port on a 2000 buick century?

User Avatar

A person needs to pay attention to their warning lights. If a service engine light is flashing, this means that there is a problem within the engine.

User Avatar

Have vehicle scanned to determine the problem and have codes cleared

User Avatar

how do i resemble the upper engine to a 1994 Buick Century? with a 2.2 litter/ vin #1g4ag5544r6420018

User Avatar

im trying to find out where the a/c low side service port is on my 95 buick century

User Avatar

I had the same problem with my 90 buick century, Replacing the temperature sensor did the trick, it is located above and behind the water pump.

User Avatar

where is the fuel fiter located on a 1989 buick century wagon 2.5l 4cyl, and how do i go about replacing it.

User Avatar

what is the order of push rods for buick century custom 3.1 engine

User Avatar

The 3.1 litre V6 engine in a 2003 Buick Century has a timing CHAIN

User Avatar

Yes, on Buick Century 1991 you need to replace the whole hub, it is much easier than replacing individual bearings.

User Avatar

The 99 Buick Century 231 engine will fit into a 96 Chevy lumina with a little fabrication.

User Avatar

code 26 buick 1990 lasabre limited

User Avatar

The spark plug gap for a 1993 Buick Century is: .045 for the 4 cyl 2.2 engine .060 for the V6 3.3 engine

User Avatar

right side of engine compartment

User Avatar

The 2001 Buick Century came equipped with the 3100 V6 (engine code 'J'). The cooling system capacity is 11.6 quarts.

User Avatar

The 3.1 litre V6 engine in a 1997 Buick Century has a timing CHAIN

User Avatar

Usually indicates a problem in the emission control system - have vehicle scanned to determine the problem

User Avatar

Simple answer is no. They use a completely different engine harness. It can be done, but you have to change all the wiring under the hood. The 3300 engine is probly the better engine, but the 3100 engine is a good motor, but are prone to more problems.

User Avatar

It's on the front side of the engine, and low.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.