You may have an electrical fault code. Have the codes read by a service tech.
The check engine light on a 2000 Plymouth Grand Voyager will come on when an error is detected by the vehicle's computer. The cause can range from low oil to mechanical problems or incorrect timing.
if you disconnect the battery for at least 5 minutes then reconnect it ,it will reset the check engine light
There are 2 lights. One is a check engine light which means the emmisions system needs service and there is a problem with the OBD system. Another light is a service light which just means you need to change the oil. Your owners manual will tell you which is which.
After reading the code, and repairing the codes, you reset code with a scan tool.
Defective computer these vans are known for this
Broken or rusted out exhaust system.
sounds like the clock spring is shot Take it in for service, the airbag system is not for diy'rs.
The door being open.
Have the engine controller checked for faults then serviced and the light turned off. Take it to the dealer.
The service engine soon light is illuminated by a signal from the computer to indicate a sensor(s) has detected something wrong. While you are driving around, stop by AutoZone or a similar auto parts store that offers free computer scanning to retrieve the trouble code(s) to see what went wrong.
The service engine light is the same thing as a check engine light.
The maintenance required light requires a scan tool to be reset.
Turn the ignition key off and on three times. You will see the check engine light go off and on. Count the times the light goes off and on. Those are the codes.
The check gauges light comes on when one of the guages is out side of the safe zone. It could be battery voltage, oil pressure, engine temp....
You repair the cause of the code, then reset the code with a scan tool or by unhooking the battery.
Either with a scanner, or cycle key on, off,on,off,on. and count the flashes of the check engine light. three pause three would be 33
Yes, the Service Engine Soon light is the same as the Check Engine light.
it is a warning light of course
the reverse light switch is usually mounted on the shifter inside the car.
2 screws, up/down. left/right
reset service engine light
The plastic is melted on the back of the light wear the two metal touches
You can clear a service engine soon light in an Infinite G35 by checking to see if the "check engine" light is flashing. If it is isn't, go ahead and clear the service engine light.