I sent my original module to a company i found on Google - www.myairbags.com They reset it for $55 and shipped back to me for free!
The system is finished displaying trouble codes in the odometer.
You have to use a scan tool.
A scan tool is preferred.
With a scan tool.
I use a scan tool.
Both of these codes indicate a leak in the evaporative emissions control system. The most common cause of this code is a bad fuel gas cap.
The airbag light stays on when there is a malfunction in the system. The computer needs checked for codes, and the cause repaired for the light to go off.
Pulling a fuse will not clear codes on this vehicle. A scan tool is required to clear codes.
Air up the tires and drive it. If it is still on, you will need to have the system checked for codes.Air up the tires and drive it. If it is still on, you will need to have the system checked for codes.
You need to have the trans computer checked for trouble codes. The car will not shift out of 2nd when the system detects a problem and sets a code.
You need to have the system checked for codes. Any electrical problem with the trans can cause a no shift.
The transmission computer will default to second gear when it detects a malfunction. You need to have the system checked for codes to know possible causes.
Replace the crank sensor located on bell housing of trans.
Have it checked for codes, That is the same as the check engine light.
The first two steps are check the fluid and check the computer for trouble codes.
The first two steps are to check the fluid and check the computer for trouble codes.
Take it to a service shop and have the trans checked for codes.
You first need to have it checked for codes, you then fix the cause of the code, you can then clear the code with a scan tool.
It will depend on the trouble codes. If they are circuit codes, you have a wiring problem. If they are other codes you could have a vacuum leak, stuck egr valve, or engine malfunction.
The first step is having the computer checked for codes. When you know the failure code you can diagnose for possible causes.
-ABS system codes for 1995-98 = code 43 rear right inlet solenoid valve.
That comes on after cycling the key three times to see any trouble codes. Done, is either end of codes, or no codes present.That comes on after cycling the key three times to see any trouble codes. Done, is either end of codes, or no codes present.
There are dozens of things that turn the light on. TAke it to auto zone and have the codes read.
Best thing to do (and its free) take it to an auto parts store. Use their code scanner to erase all codes in the computer. Takes no more than 5 minutes.
The airbag light stays on when the computer has detected a malfunction and set a code. The codes need checked with a scan tool to know possible causes.