If I recall correctly the 1986 Escort had either a 1,6 diesel or a CVH petrol engine. In any case your car radio (even from 1986) will have more electronics than the rest of the car.
Check your local auto salvage yard (junk yard).
The distributor is set to 0 degrees with the scan tool and the computer does the rest.
No, the bolt pattern on the Contour is 4x108mm (like the Tempo and the Focus), and the bolt pattern on the ZX2 is 4x100 like the rest of the Escorts, so the the bolt holes won't line up.
It is set by the computer. As long as you put the distributer in at the correct location the computer does the rest.
The powertrain control module (PCM) is mounted through the firewall on the passenger side. You can see one end of it with the wiring harness from the engine compartment , and the rest of the PCM is "hidden" inside the Explorer behind the glove compartment . Helpfull
I know that they have R15 in the size I don't know the rest original tires are 165/70 R13 for the 96 and 97 aspire
Yes, you can use a rear center head rest from a ford escape 2007 in a ford escape 2009 with a little fabrication.
It should be passenger side behond kick panel. Just push rest button if that is your problem
What about it? Where is the rest of the question?
There is a serpentine belt listed for the 1996 Ford Ranger - 2.3 L - 4 cylinder engine without power steering / without air conditioning all the rest of the serpentine belts listed for the 2.3 L / 3.0 L / and 4.0 L engines have power steering with and without air conditioning
motherbourd and north brige for the ram
Sounds like the chip in your key has malfunctioned, take it and the vin of the vehicle to a ford service center, or any place that can make keys with the chip and have it checked.
Which is the part of microprocessor that tells the rest of the computer system how to carry out programs instructions?
where is the fuel rest bottom on a 93 ford explorer.
Kablam - 1996 You've Tried the Rest Now Try the Best 1-13 was released on: USA: 1996
He jacked off the rest of his life :)
Using a screwdriver, remove the screws and the clips in the door panel and pull the panel away from the frame. Remove any wire connections between the two, and the panel will come off the rest of the way.
You can see the wiring harness to the POWERTRAIN CONTROL MODULE ( PCM ) in the engine compartment , on the firewall , on the passenger side . The rest of the PCM is " hidden " behind the glove compartment
oh give it a rest its 45th
The motto of AMA Computer University is 'Never rest on one's laurels'.
you get it close, and the computer does the rest.
The belt that I used my my 1999 ford escort ZX2 is a 6K730 to bypass the A/C. when routing the difference is the belt will come from the power steering to the tension pulley to the crank then water pump and the rest is normal. I hope this helps