i just put a new head gasket in and i got everything put back together all the wiers connected the motor rotats but wont start it gets spark it seems like its not getting gas the tank is full all i can think is vapor lock cause i had it taken apart or do i need to prim it some??
Once it cools off it will start.
It is impossible for a fuel injected car to vapor lock. If you have a check engine light on then you need to address that problem first.
pressurized fuel system with return lines can not vapor lock. its something electricl, you dont give enough info to guesstimate the problem
Could be vapor lock. The vent on your gas cap may be clogged
Sounds like it could be vapor locking. Try putting a few wooden clothes pins on fuel line
good luck left rear bumper no room for both hand took me 4 hours
Dihydrogen Monoxide.
gas, vapor
Check the gas cap there is a possibility that the vent is clogged and causing a vapor lock.
vapor
This is called a "hot restart problem" and is commonly caused by vapor lock, which is the accumulation of air bubbles around the main jet, emulsion tube, etc. Most immediate solution is cleaning and rebuilding of the carburetor, particularly the bowl vent and main air bleed. An alternative would be to lean out the mixture via the needle valve, if equipped.
superheated vapor is a vapor that has been heated above its boiling point.