Try this. Turn radio off. Push and hold down power button. Push scan and/or seek up or down to set clock. This works with some Chrysler radios.
TURNN RADIO OFF PUSH AND HOLD VOLUME NOB USE SEEK AND SCAN FOR HOURS/MIN.
How do I set the time?
Push the set button and within 10 seconds press the seek and scan buttons.
Unplug and reconect the coolant temp sensor.
To reset the mpg, and timer. You need to press and hold both buttons for about 5 to 6 secs.
If it is like my 1991 caravan, turn the key on, hit the "Set" key so "P" appears on the screen, then push the select key, and you are now on time settings, use your dial to dial in the time and hit "set" once finished.
Use the set buttons.
On my 1991 caravan, turn the key on, hit the "Set" key so "P" appears on the screen, then push the select key, and you are now on time settings, use your dial to dial in the time and hit "set" once finished. (self discovered, and answered to share information)
use a pen and adjust the hours and minutes on the radio by pushing in the switches in the two little holes on the right side of the radiojust next to the right knob
To set the clock on a 1989 Corvette the radio must be turned off. After turning the radio off hit the set button and then hit scan. The time can be set using the arrow buttons.
Usually Caravan tires should be set at around 35 or 36 psi.
My 2000 Dodge Durango , my clock does not have the h or the m for setting the clock! any suggestions on how to set the clock????? Turn radio on, press set, press sel, now seek should change time.
You can set the clock, on your 2005 Dodge ram, by holding in the volume button. Turning the tuning knob as the volume button is held in. The time will advance with the tuning knob.
If the radio is the same as the 98 caravan, there are two tiny buttons to the right of the display with the letters H and M to the left of them, sstanding for hours and minutes, just use a toothpick to press each one until the desired time is displayed.
look in your owners manual.
The clock on the radio can be set by two buttons found to the right on the display screen. H for hour and M for minute.
It is on because the abs computer has detected a malfunction and set a code.
To the right of the clock there are two small buttons labeled HR & MIN. Simply push and hold them in (one at a time) with a pen or equivilent pointy object to set clock
It increases the cruise control set speed.
set it at top dead center the computer does the rest
Read your owner's manual. This information can be found there.
look to the right of the radio for a button that says clock. push it and your display shoulg show "set hour" or something similar. use the radio tuning knob to set the hour. push the button again for minutes and use the tuning to set them. if you have an older van there 2 small/tiny buttons to the right of the radio display screen. use a pen tip to push them. they are marked HH and MM.
The timing on a 1989 Dodge truck should be set to 10* after unplugging the temperature sensor.
Press the set buttons for hour and minute.
If its the factory unit, look at the face of the unit and there should be 2 tiny little buttons (holes) on the front. One has an H (hours) next to it and one has an M (minutes). Use a paper clip or a pen and adjust the time.