Hoo I set the correct timing on a 1993 mazda protege
I found this out through trial and error. Hold the "clock" button down until it starts blinking. Use the "Tune Seek Track" button up for hours, down for minutes to set the clock. Hit the "clock" button again to save the setting.
how do you set the clock on a 2003 chevrolet trailblazer
This one really sucks. You have to purchase a new set of wires for your protege, and Mazda makes this really expensive.($210.00) Nology makes a really good set that you can order on the internet. It is a special set up since Mazda uses a coil on plug system.
You can set the clock in your 2003 Ford Escape by holding in the volume button. With the volume button held in the clock display will flash. You can then set the clock by turning the tuning knob.
To set the clock on a 2003 Ford Mustang radio press the menu button repeatedly until the hours and minutes display on the screen. From there use the up and down arrows to set the clock.
Hold the clock button in the use the the radio seek button to increase or decreas the time.
i don't know ,sorry
hold clock+seek for Hours hold clock+discs for minutes
Press and hold the set button until the clock appears, then adjust the time using the scan buttons.
Press and hold the clock botton. After the beep, both hour and minute values will be blinking. You can then set the clock by pressing the H for hour or M for minute.
a picture of the radio would be helpful
Hold the volume knob in. The clock will flash. Adjust the clock with the tuning knob while holding the volume knob in.
This information can be found in the owner's manual.
How to change Mazda 3 Clock settings To set the hour: 1) Put ignition in ACC or ON position 2) Press and hold "CLOCK" until beep sounds and "12 hr/24 hr" is displayed; 3) Press "SET" to select 12 or 24 hours (24 hours is military time) 4) Press "CLOCK" again while the selection is flashing "Hr ADJUST" 5) Press "SET" to select hour 6) Press "CLOCK" when done Do the same to set minutes, but select Minutes in step 4
Push and hold the “clock” button until it beeps. Then use the tuner button to change the time. (Up to change the hour and down to change the minutes.)
on my 91 you take out the two Phillips head screws put them in the other set of holes and as you tighten it will push the drum off
Press and hold the clock button to the left of the display until the selection for 12 or 24 hour time comes up (note 24hr time is military time)...after selecting 12 or 24h, the hour should be blinking, press set for each hour to increase, press clock to change to the minute selection and press set to increase the minutes, press clock when you are done.
On the gauge cluster, there are 2 knobs. Twist the right one to the right.
On the radio there is an icon that looks like a clock. It should be the top right button. Press the button and the time display will appear. Turn the tuner knob to adjust time and then press it to set the time. As soon as you set the time, the clock on the instrument cluster will automatically set.
how do you set the clock on a 2001 oldismobile aurora
'how do I set the clock on a 2001 mercury mountaineer'
How do you set the time on a S10/Scan atomic clock model 86715
uhm i dont think you can set an alarm clock, but you can have a clock on your zune. go to settings and scroll till you see clock, click 'show clock' to yes and set the time to either 12 or 24 hour setting then set your time
there are two little buttons recessed in to the right of the clock. Use a pen or something similar to push the buttons in. top is for the hour and bottom is for minutes