it sounds like your wheel bearing if its a whaling noise
To change the time on a 2004 Renault Scenic, turn on the ignition without starting the engine. Press the "Menu" button on the dashboard to access the settings, then use the arrow buttons to navigate to the clock settings. Adjust the hours and minutes using the corresponding buttons, and confirm your selection. Finally, exit the menu to save the changes.
Setting the clock on your Renault Scenic is as easy as painting happy little trees. Simply locate the clock button on your dashboard, press and hold it until the time starts flashing. Then use the arrow buttons to adjust the hours and minutes. Remember, there are no mistakes, just happy little accidents.
You need to switch off the stereo and then you can use the buttons next to the clock to change the time. this also changes the time on the stereo.
To set the clock on a 2004 Suzuki XL7, turn the ignition to the "On" position without starting the engine. Press and hold the "Clock" button until the display starts to blink. Use the "Hour" and "Minute" buttons to adjust the time, then press the "Clock" button again to confirm the settings. The clock should now display the correct time.
There is a lever in passenger side you have to pull and another out side in the bars of grill it is a small ( T ) bar pull and lift bunet at the same time my is 2005 this is the way it works
Could be a bad fuel pump, clogged fuel filter or something in the electrical system is getting overheated like a coil or crankshaft sensor.
i had problems starting my megane it was like the battery was goin dead. it wouldn't start or would take a long time to get goin so i called AA.first AA man changed battery but still the same week later next AA man unbolted a thing called TDC (top dead center) and cleaned it no problems since
Time + Electricity = Clock or Time + Wheel = Clock
Time + Electricity = Clock or Time + Wheel = Clock
To change the clock time in a 2004 Volvo S80, first turn the ignition to the "On" position without starting the engine. Press and hold the "Menu" button on the dashboard until the clock display appears. Use the "Seek" or "Tune" buttons to adjust the hours and minutes, then press the "Menu" button again to confirm the changes. Make sure to check that the time is set correctly after making adjustments.
Press and hold the clock button at the same time press seek either way to change the hour and tune disc to change the minute