Setting the time on the Chevy Prizm is tricky. The Prizm's manual says to change the clock using two buttons labeled HR and MN -- presumably for HOUR and MINUTE. Unfortunately, these two buttons are not identified in the manual and are not labeled on the radio. The two HOUR and MINUTE buttons are the two buttons located at the lower right of the radio control panel. These two buttons are labeled with DOWN and UP arrows. ---------------------- To change the MINUTES: ---------------------- Push and hold the UP ARROW button for a couple of seconds. The minutes on the clock will begin to increment slowly. Keep holding down the button until the correct minute is reached. When the minutes reach 59 they wrap around to 0 and then keep on incrementing. ---------------------- To change the HOURS: ---------------------- Push and hold the DOWN ARROW button for a couple of seconds. The hours on the clock will begin to increment slowly. Keep holding down the button until the correct hour is reached. When the hours reach 12 they wrap around to 1 and then keep on incrementing. ---------------------- TIPS ---------------------- TIP: you don't have to turn on the car to change the time. TIP: once you get close to your desired hour or minute, you can stop holding down the button, and instead, start pressing it repeatedly. This gives you more control over setting the hour or minute, and it helps you avoid going past your desired time. TIP: when you go past the time you want, it is tempting to press the down arrow to go back. This doesn't work. The DOWN arrow only increases the hour and the UP arrow only increases the minute. You have to continue pressing the hour or minute button until the hour or minute wraps all the way around and comes back to the time you want.
Press the set button then within 10 seconds use the seek and scan buttons to set the time.
how do you set timing on 2001 malibu 3.1
Chevy S10 in 2001 didn't have a 2.0L engine. They had a 2.2L engine and it has a (DIS) distributorless ignition system. There is no timing to set.
where is fuel shut off on an 2001 Chevy prizm There isn't a fuel shutoff switch on any car. There is a rev limiter to cut back on the fuel at a set rate of speed.jd
no adjustment!! set at factory.
It requires an ENGINE SCANNER to set the ignition timing on that year of engine.
Chevy did not make a 350 in 2001. The last 350 was built in 1999.
In order to set the timing on a 98 Chevy 350 vortex, you have to time with a scan tool that will let you set timing. Or let garage do it
by changing the time
timing is set by pcm, at factory!!
Press and hold down clock button while pressing hr/min.
Wich marks can u use to set it on time if the marks are erased
Timing is pre-set by the PCM
you can't. There is no adjustment it is computer controlled.
How do you set the clock in 2007 equinox..Take it off military time
Press and hold the HR or MIN arrow for two seconds. Then press the HR arrow until the correct hour appears. Press and hold the MIN arrow until the correct minute appears. The clock may be set with the ignition on or off.
On the lower right hand corner of the radio hold down the ^ button until the radio beeps and then one button operates the hour and the other operates the minutes.
how do you set timing on a 92 geo prizm if timing belt has broken
How do you set the timing on a 2000 Chevy blazer (V6)
there is none. an 01 chevy with a 4.3 has a camshaft sensor and a crankshaft sensor that send critical info to the computer, it then adjusts timing electronically.
The timing on a 2.8 V6 Chevy S10 needs to be set any time the valves, heads, or crankshaft are worked on. The gears of the timing chain and timing sprocket need to be aligned to set initial timing.
With the key on, and the radio off. Press the SET button, then use the seek scan buttons until the time you want is reached. Press the set button, and you are done.
how do you set the clock on a 2001 oldismobile aurora
advance auto parts has a good set for about 45 bucks on my 1.6