Auto Parts and Repairs
Timing and Firing Orders
Chevy Silverado
Chevy 350

How do you set the timing on a 1988 fuel injected Chevy S-10 pickup with a 2.8 V-6 engine with an automatic transmission?

313233

Top Answer
User Avatar
Wiki User
2015-07-16 18:27:17
2015-07-16 18:27:17

you have to undo a single wire plug under the carpet on the pasenger side. then the computer is in sleep mode. Set at 0 degrees, then shut off, reconnect the plug and start,,,, it will automatically adjust itself.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

1987 NISSAN/DATSUN PICKUP 3.0L 6-cyl EngineCAPACITIESAutomatic Transmission, Total Fill2wd ..........7.4 quarts4wd ..........9.0 quarts 1987 NISSAN/DATSUN PICKUP 2.4L 4-cyl EngineCAPACITIESAutomatic Transmission, Total Fill..........7.4 quarts Hope This Helps.

User Avatar

Automatic transmission dip stick is found in back of the engine, passenger side.

User Avatar

You add automatic transmission fluid to a 1989 V6 3.0 Toyota pickup truck through the filler tube in the engine compartment. This is also used to check the fluid level.

User Avatar

= What is the automatic transmission fluid capacity for a 1994 Chevrolet 1500 pickup? =

User Avatar

it was standard but you could order it with an automatic from the factory

User Avatar

It is on the side of the transmission were the shifter cable hooks to the trans.

User Avatar

28 to 32 for the dwell and for the timing, TDC if it is standard transmission, 4 degrees BTDC if it is automatic transmission.

User Avatar

There is no choke. The engine is fuel injected.

User Avatar

Should be at the side of transmission with a vacuum line attached to it

User Avatar

Where can I find a wiring diagram for a Ford 1991 F250 pickup with 5.8 liter V8 and automatic transmission with overdrive?

User Avatar

no, it wouldn't be worth the effert. The auto requires an oil cooler different linkage, and a different engine computer than the manual uses.

User Avatar

The specs of a Chevrolet pickup truck typically include either automatic or manual transmission, V6 or V8 engine, Am/FM radio with built in CD player, and rear wheel drive.

User Avatar

Standard or automatic transmission, they both are mounted to the transmission.

User Avatar

This depends on many factors. Which engine do you have, which transmission? how is your suspension? For example. My 87 pickup is a V6 with an automatic transmission. Tow weight is around 2600 lbs (about 1179 Kg) On the other hand, my father owns the standard transmission model of the 89 pickup with a V6 which can haul approximately 3500 lbs (about 1587 Kg)

User Avatar

If your checking the level of the tranny fluid in an automatic you need to turn on the engine let it idle in park NEUTRAL and pull the dipstick.

User Avatar

It is important to check the fluid levels of a car. The transmission dipstick of this car is under the cars hood, behind the grill on the front of the engine block and has a red seal.

User Avatar

You add A/T transmission fluid at the same place you check it.

User Avatar

As with nearly all automatic transmission the fluid goes in through the dipstick tube.

User Avatar

Assuming you have an automatic transmission, the dipstick should be located toward the rear of the engine on the passenger side. With vehicle warmed up and parking brake applied the transmission fluid is checked with the transmission in neutral.

User Avatar

An automatic transmission to bolt up to the original 1959 6 banger would have to come from a 1962 or older chevy/GMC 6 pickup or passenger car. 1963 and newer is completely different.

User Avatar

It will bolt up, but the internal sensors are wired differently. So it will not shift.

User Avatar

It is in the gas tank, you will have to remove fuel tank to service the pump.

User Avatar

Depending on automatic or standard transmission and gear ratio, probably between 16-19 mpg.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.