answersLogoWhite

0


Best Answer
Copy

find the timing spec on the label under the hood ( i think its 10 degrees BTC) get engine to operating temperature find the grey plug in the engine compartment labeled "diagnosis" open the cover and with a jumper wire, connect tmls. TE1 and E1 (this makes the engine run at base timing) clamp timing light around #1 plugwire clip power and ground leads of timing light to battery shine on timing marks, if the timing is off loosen the 2 12mm bolts securing the distributor to the head and twist until the mark on the pulley matches the spec. tighten the bolts remove timing light and jumper

IGNITION TIMING: Carburated models Without vacuum advance hose connected: 3 degrees BTDC. With vacuum advance hose connected: 12 to 18 degrees BTDC.

1990 through 1993 fuel-injected models With test terminals T and E1 grounded: 10 degrees BTDC. Without test terminals T and E1 grounded: timing fluctuates between 7 and 17 degrees BTDC.

1994 fuel injected models With test terminals TE1 and E1 grounded: 10 degrees BTDC. Without test terminals TE1 and E1 grounded: timing fluctuates between 7 and 17 degrees BTDC.

User Avatar

Wiki User

โˆ™ 2015-07-16 18:19:50
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you set the timing on a 1989 Toyota Tercel?
Write your answer...
Submit

Related Questions

How to set timing on 1996 Toyota Tercel?

you cannot adjust the ignition timing on this car. a manual will help if you need to set cam timing


What is the crankshaft and camshaft location when installing timing belt on a 1984 Toyota Tercel?

Get a shop manual from the parts store and it will show you what to set them at and give tips on how to replace it. GoodluckJoe


How do you set timing belt on a 1993 tercel?

To set the timing belt on a 1993 Tercel the cam shaft markets must be lined up top dead center. There are arrows engraved on the engine labeling where exactly to install the belt. Failure to correctly set the timing belt can lead to catastrophic engine failure.


How do you set the timing on a 1993 Toyota Corolla?

How do you disconnect the Data Port when setting the timing on a 1993 Toyota Corolla?


How do you set timing on a 92 Toyota 4-runner 3.0?

What should the timing be on a 92 Toyota 3.0


How do you install a turbo system on a Toyota tercel?

you just dont, you buy a 3sgte and then youl be set.


How do you set the timing on a Toyota Tazz?

you twist the buttons


How do you set timing on a Toyota 22R engine?

To set the timing on a Toyota 22R engine find the distributor. The engine will have marks at which the distributor can be set. The OEM setting for a 22R engine is 5 degrees.


How do you set timing on a Toyota 3.0 doch?

I only know about the 2004 V6 I have. There is no way to set the timing. The engine computer controls the timing. Not much one can do to newer cars today. Some of the members of the Toyota Nation forum are interested in more power and performance. Maybe one of them can tell you how to set the timing. If you are talking about changing the timing belt,visit Toyota Nation forum.


Set the timing on 2000 Toyota 2.2 liter 4-cylinder?

videos on how do you set the timing mark on a 2000 Toyota Camry Solara 2.2 liter , 4 cylinder


How do you set the timing for an 1989 Caprice Classic?

ssaaa


How do you set the timing on a 1997 Toyota Tacoma 2.4 liter?

What are timing marks for 97 tacoma 2.4


How do you set the ignition timing on a 1989 Acura Integra?

Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.


What does the symbol under the oil light mean on a 94 Toyota tercel?

On a stock 1994 Toyota Tercel, the warning lights are located in two sets of three warning lights, one set under the fuel gauge and the other under the temperature gauge. The lights are horizontally set, not vertically, so there is no symbol underneath another. It is possible that the instrument cluster was modified, as the Tercel is a favorite for modifications.


Ignition timing specs for 1989 Chevy G 20 van?

How do you set the timing for an 1989 Chevrolet G20 van - 350 cu. in. with tbi?


What is the timing spec on a 1989 S10 4.3L V6?

Follow the directions on the emissions label under the hood of your car, it will tell you what to set the timing at and what connectors to disconnect to set the timing.


How do you set a timing belt for a 1991 Toyota tercel?

just did the timing on my 91 tercel... very easy... only problem i think im a hair off... runs great but when doggin it, it has a slight hessatation until high rpms and then skoots off.. ima borrow a friends timing light and see whats the deal... your best bet is to hit up autozone or advanced auto and buy a HAYNES book... that's what i used plus a little past knowledge and it worked out easily...


How do you time 1989 Nissan 1600cc engine?

How to Set timing on nissan sentra 1600cc 1989 model


Where is the timing gauge on a 84 Toyota Cressida?

There is no such thing as a timing gauge on a car. Timing is set with a tool called a timing light and a mechanic can do that for you and doesn't cost much money.


How do you set the timing on 1989 Dodge Dakota 2.5L?

set it at top dead center the computer does the rest


How do you adjust the idle speed on a 1989 Toyota truck with a V6?

You shouldn't. The idle speed is set at the fatory. Instead look into testing your TPS and VAM. Check timing and and test O2 sensor.


What should the timing be set at for a 95 Toyota truck?

There should be information regarding the timing degree on a decal locaded under the hood.


How do you set the timing on a 1995 Toyota Corolla?

First why do want to? timing is never a needed adjustment unless the distributor has been removed.


How do you set the timing on an 1985 and 1989 Chrysler 318 that has no timing degree makers on the block but there is a line in the balancer?

I'd just set it by ear and how easy it starts once it's set.


How do you set the timing on a 1989 Toyota pickup with 22-re engine?

On the toyota, you have a little 'diagnostic' box on the left side, if you look under the hood it will tell you which terminals to short out with a wire which disengages the spark advance. I think the yota is set 5 degrees before top dead center.