What is the set timing of a 1992 Mitsubishi Expo?
how to time a 1999 Hyundai elantr glsAnswerhow to set timing belt on Hyundai elantra gls figure
My ELANTRA'S camadjuster brake. what is the correct way to set the valvetiming?
To set timing correctly on a 1992 Honda Civic the distributor must be installed at the right angle. Install the distributor at the correct degrees to ensure the timing is set properly.
how do i set my timeing on a 1992 cadillac v8 4.9 liter
how i can set 1997 Mitsubishi diamante timing beltAnswerhow i can set 1997 Mitsubishi diamante timing belt
The computer should set the timing automatically by the sensors. If you change it, it must be done with a handheld computer.
The timing should be set at 0 degrees.
When it is disconnected it puts the electronic timing control module in limp mode,and then you can set the timing with a timing light.
You don't- it's controlled by the PCM. If is has a 2.5 engine you cann't adjust the timing
my book says 5 degrees BTDC
Computer controlled and not adjustable
After disassembling to expose timing belt, look for TDC and ATDC timing marks. Align them, allowing 43 centimeters. Set BTDC mark in like manner.
No , computer controlled
clean on the front of the pump on top where it bolts on the motor there are timing marks there line up the long marks to set the timing.
The timing is set by timing marks on the crankshaft pulley. Using a timing light the light will sync with the engine and show if the marks line up properly. To adjust the timing the distributor is turned slightly. There is a clam and bolt under the distributor, loosen these just a bit to be able to move the distributor.
what timing are you trying to set? the cam timing or the ignition timing?
Get the Haynes manual for the unit, they have a good, detailed diagram on aligning the timing marks on the timing gears being turned by a chain. There is no belt on this engine.
Timing is set by the PCM and is not adjustable.
how do I set the timing on a BMW 740
how do you set timing on a 92 geo prizm if timing belt has broken
You can not set the igitniton timing yourself.You can check it but not set it.The timing is ran off a crankshaft sensor.Idle timing is 27 degrees
trying to set base timing on a 97 Chevy c1500 with a 5.7 engine the wire to disconnect to set base timing is ?
how to set ttr125 timing