answersLogoWhite
Timing and Firing Orders
Chevy Silverado
Chevy 350

How do you set the timing on a 95 silverado with a 5.7?

151617

Top Answer
User Avatar
Wiki User
Answered
2006-09-15 02:48:16
2006-09-15 02:48:16

On that vehicle there should be a "CATALYST" sticker somewhere under the hood that will tell you what the timing should be and whether to check it with the vacuum hose disconnected or what. Of course you know you need a strobe timing light and to have read the instructions that came with it, right?

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.


can u give me a diagram on the timing marks for my 95 hyundi elantra


The distributor is set to 0 deg with a scan tool. It can not be done with a timing light.


The ignition timing is non-adjustable. It is strickly electronic, and you cannot change it. The valve timing is controlled by the timing belt. If it has jumped time, you have to remove the timing cover to access the belt, replace it, and set it to the correct specifications.



60%******************************The correct answer is: 57 ÷ 100 × 95 = 54.15


There should be information regarding the timing degree on a decal locaded under the hood.


The same as the gcf of 57 and 38. 38 is the remainder of the division of 95 by 57.


I have 1999 chevy Silverado z71 wanting to see if a 1994-95 chevy Silverado z71 bed will fit



You dont. It is an LT1 engine and the distributor is behind the water pump.


No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.



Yes it will fit right in there.



There is only one way, the timing chain MUST be right for the engine to operate properly. If the camshaft was set up wrong, the front of the engine must be disassembled and the timing chain must be set up properly.



The Least Common Multiple (LCM) for 95 57 is 285.


You can set the cam timing, on your 1995 Yamaha motorcycle, by synchronizing the fuel and exhaust valves to the camshaft position. This can be accomplished by adjusting the valve of adjustment screws.



57 is three fifths of 95


No. It has a DIS (Distributorless Ignition System)


60 percent of 95 = 0.6 * 95 = 57


40% off 95 = 95 - (0.40 x 95) = 57


There is no provision for setting the timing. It is controlled by the computer according to engine load, temperature, intake charge and mass air flow.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.