Want this question answered?
A land- line telephone uses transmission in FULL DUPLEX mode in which simultaneous transmission and receiving of information takes place in both direction. There are three modes of transmission: 1.simplex transmission 2.half duplex 3.full duplex
3000 meters above the water line
A T1 line provides you with 1.544Mbits per second, full duplex. Full duplex means that, you get the 1.544Mbps in up- and download direction. 1.544 Mbit per second equals 0.192MByte per second.
A T1 line provides you with 1.544Mbits per second, full duplex. Full duplex means that, you get the 1.544Mbps in up- and download direction. 1.544 Mbit per second equals 0.192MByte per second.
The direction of the data flow can be described as: 1. Simplex 2. Half duplex 3. Full duplex 1. Simplex:- In Simplex data flows in only one direction on the data communication line (medium). Examples are radio and television broadcasts. They go from the TV station to your home television 2. Half duplex:-In Half-Duplex data flows in both directions but only one direction at a time on the data communication line. For example, a conversation on walkie-talkies is a half-duplex data flow 3. Full-Duplex: In full duplex data flows in both directions simultaneously. Modems are configured to flow data in both directions
Such a line is said to work in duplex mode. Many technologies allow sending and receiving simultaneously.
line = raw_input("Enter the plaintext") line1=raw_input("Enter the plaintext ") line2=raw_input("Enter the plaintext ") split =len(line)/2.0 split=round(split, 0) split=int(split) line = line[split:] + line[:split] line = line.replace("E", "o") line = line.replace("O", "e") line = line.replace("YAR", "ray") line = line.replace("RAY", "yar") split =len(line2)/2.0 split=round(split, 0) split=int(split) line2 = line2[split:] + line2[:split] line2 = line2.replace("E", "o") line2 = line2.replace("O", "e") line2 = line2.replace("YAR", "ray") line2 = line2.replace("RAY", "yar") split =len(line1)/2.0 split=round(split, 0) split=int(split) line1 = line1[split:] + line1[:split] line1= line1.replace("E", "o") line1= line1.replace("O", "e") line1= line1.replace("YAR", "ray") line1= line1.replace("RAY", "yar") print line.lower() print line1.lower() print line2.lower()
Water line rates in the UK are based on your house value. A small fee is also added to your bill. Your Billing is calculated once a year. Meters are used my water companies to measure use.
The length goal line to goal line is 100 meters and from touch line to touch line its 69 meters. Both sizes are regulated by the IRB.
8*line square metres!
3.048 meters (10 feet)
Regulations state that a pitch shall not exceed 100 meters goal line to goal line and 70 meters from touch line to touch line. The area on this is 7000 sq meters