answersLogoWhite

0


Best Answer

Make sure the drain line and the vent are cleared. Noises like that are usually caused by either restricted flow or a plugged drain vent.

User Avatar

Wiki User

โˆ™ 2006-03-13 16:33:07
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you stop a new gurgling in your kitchen sink after installing a new sewage sump pump?
Write your answer...
Submit
Related questions

Do you need a sewage or grinder pump?

Depending on what. Mostly is a sewage


Installing airmatic pump on a 2001 s500?

installing airmatic pump on a2001 s500


Who invented sewage grinder pump?

How invented sewage could you please tell me the answer How invented sewage could you please tell me the answer


When using a sewage pump to install a shower and toilet in a basement how do you connect the trunk line into the sewage basin?

The sewage pump out is installed downstream of a bathroom group from the upstairs plumbing Consult a plumber and/or the plumbing code. If you do this wrong you WILL regret it later. Keep in mind you are dealing with raw human sewage. Do it right the first time, for your own sake.


Do you need to fill the fuel pump before installing?

No.


What is the tank with spouts called in sewage works?

"Tank with spouts " may refer to either the 'settling tank' or the 'pump tank' in most sewage systems.


Should a sewage ejection pump go on everytime the toilet flushes?

No way


Do you have to reset the computer after installing a new fuel pump?

no you dont have to reset the computer after changing the fuel pump


How do you install a heat pump?

Installing a heat pump properly is best accomplished by an experienced person or professional.


How do you prime a new oil pump?

I've always packed the new pump with petrolem jelly prior to installing it


Is it possible to reduce from two inch to inch and a half on a sewage pump?

It's possible, but NOT recommended


How to find out what type of sewage pump you have?

By disconnecting it from the piping , clean it off and look at the manufacturers tag


How do you change a power steering pump for a 2001 Kia Optima?

installing power steering pump 2005 kia optima


How can humans damage rivers?

pump sewage into it for a start, or over fish it. or put toxic substances and stuff in it


How do you you increase psi on pump and filter?

by restricting the flow and installing a pressure switch.


What causes your kitchen sink to shake when the faucet is on?

The water pump.


Water Pump ?

form_title= Water Pump form_header= Install a water pump in your home. Do you need to remove an old water pump?*= () Yes () No Are you installing a pool in your home?*= () Yes () No Do you want an energy efficient water pump?*= () Yes () No


Does the water pump have to be replaced when installing an engine?

No. But if the pump is driven by the timing belt, it is good practice to replace the pump at the time of installing the engine. A pump failure will cause the timing belt to jump. In the majority of cases this will cause valve to piston contact. Plus, if the part is hard to change, maybe you should do it now rather than later, when it will be much harder to get to.


Would a failing water pump or pump seal allow air to get into the coolant lines and make a gurgling noise when you rev the engine?

having this happen to me it was a blown head gasket. it also may be a cracked head. it had nothting to do with the waterpump. sorry!!


What direction should the arrow on a fuel pump go when installing?

The fuel pump arrow points away from the fuel tank and points toward the engine.


How much antifreeze do you put into 1999 Cadillac deville after installing a water pump?

2 gallons


Installing water pump on 94 Toyota Celica?

Secure your 1994 Toyota water pump with the retaining bolts. Connect the water pump hose. Put the water pump belt on to the water pump pulley. Fill the cooling system with anti-freeze.


How do you change a water pump on a 1999 mercury mountaineer?

On the v8 model the water pump is fairly easy to reach, its just a matter of unbolting the pump and installing the new one. On the v6 model, the radiator will have to be removed to access the pump.


No fuel to filter after installing new fuel pump on dodge with cummins diesel?

The lift pump must have failed, or the pick up tube in the tank has broken.


Can a fuel pump be installed incorrectly in a 2008 Hyundai Elantra to cause the gas gauge not read accurately?

No, you installing a fuel pump has nothing to do with the fuel gauge