How do you stop your 95 cutlass ciera from clunking when you put it in reverse?
Sounds like a transmission problem
What causes a 1990 cutlass ciera hesitate and sputter when gas pedal is depressed or crusing and symptoms stop when brake is applied?
What causes the tail lights dash light AC panel light ashtray light and fog lights to stop working on a 1992 Oldsmobile Cutlass Ciera?
You Think your BMX freewheel is making a clunking noise when you peddle. when you stop pedaling you cannot hear the clunking anymore you can only hear it when you apply pressure to the peddles.?
When you put it in reverse it make a noses and will not go anywhere but you put it in to neutral it will stop?
Generally, the auto reverse on a cassette is triggered by a sensor located inside the deck. This sensor is a little wheel that is turned by the tape going over it. When the tape stops turning the little wheel, this triggers the auto reverse function. Unfortunately, to stop the auto reverse you'd have to take the deck apart and unhook the sensor. Sorry
Why don't the door locks on a 1993 Cutlass stop running until the fuse is pulled but then the brake lights don't work?
Does your car have a remote for keyless entry? I recently had to program a remote for a 1992 Cutlass Supreme. The procedure involves removing the trim on the passenger side of the trunk, near where the antenna sits on a 2 dr. Once you pull off the trim, you should see a wire with a black connector on the end, coming from the passenger compartment of the car. To program a remote, you use…
Have a 1990 Ford Tempo GL, The car dies when you put it into reverse or you come to a stop. have replaced plugs, wires, Idol sensor, and cleaned the injectors. Its still doing it. Have a 1990 Ford Tempo GL, The car dies when you put it into reverse or you come to a stop. have replaced plugs, wires, Idol sensor, and cleaned the injectors. Its still doing it.