answersLogoWhite

0


Best Answer

You will need to take a screwdriver or knife to take the intake off of a 1986 2.9 Bronco 2. Just take and pry the intake off. It is very easy to do.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take a intake off a 1986 2.9 bronco 2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you manually roll up a 1986 ford bronco rear window?

If its the bronco XLT you'll have to take the tail gate paneling off the inside. The motor, gears, etc. for the rear window are located in there. I had the same problem with mine sometime back.


Where is the PVC on a 1986 couger 5.0?

the pcv is at the back off the engine under the upper intake in the lower intake


Can you take the top off your 96 Bronco?

See the link below.


What years or bronco could you take the top off?

All of the full size.


Can you take oil pan off 1989 bronco without removing the engine from the vehicle?

how to remove oil pan from 1989 bronco 2


Where is the starter motor on BMW Z3?

The starter is located under the intake manifold, and you will have to remove the intake manifold to get to it. Do not forget to buy a intake gasket before you take it off, because they always fall apart when you take the intake manifold off.


How do you fix intake gasket?

You take off the carburater and the intake. Clean the old gasket off and install the new one.


How do you install an intake kit on a 1989 rx7?

take off the stock intake. it should pull right off....slide the new intake pipe in where the old one came off...


Can you take the top off of a 1973 bronco half cab?

yes it unbolts and comes right off. you will have to take off the wind shield wiper motor cover.


Just how do you change the wiper motor in a 88 Bronco II?

look at autozone.com for great repair manuals online on the firewall right behind the intake, there is a cover with 3 screws. take the cover off and here is one nut holding on a small place with a slot in it. just line it back up and put the nut back on. much easier with the intake off.


Do you take off intake when changing the timing belt?

NO.


How do you change upper intake on 350 Chevy engine?

you take off carb or tbi and the take off all braces from intake. take out distributor and coil(you will need them later) and then take all the fastener bolts of and replace intake. put all of the things back on