answersLogoWhite

0


Best Answer

Depending on what is meant by "heater control", the ashtray may not have to come out.

If it's referring to the temperature blend door actuator motor (the most common climate control failure on Windstars), only the radio is suggested to be pulled. Even that is optional to make it easier.

Hang on a minute and I'll run out and check on the ashtray thing... (insert elevator music here)...

Okay I'm back.

The ashtray / beverage holder is held in with 2 7mm screws - you'll have to bend over and look into the dark corners on each side to spot them.

AnswerIf the cupholder on the 2002 Windstar is the same as the 2001 then there is a small plastic clip on the top of the cupholder that locks in a groove when the cupholder is in the out position. Push the clip down with a small screwdriver and pull the cupholder out. (This works on a 1998 Windstar, also.)


See "Related Questions" below for more
User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take beverage tray out of dash for heater control replacement on 2003 windstar?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

99windstar temperature control?

heater windstar ford


Where is the location of heater control valve on 1998 ford windstar?

The "Related Question" below is an extensive discussion on the 1999-2003 temperature control valve / heater control valve. It is likely the information will be similar to the 1997 / 1998 Windstar


Where can you find out online how to remove and install a heater box in a 1999 Ford Windstar?

There are 3 primary questions about Windstar heating & cooling problems: * Temperature blend door actuator motor replacement * Heater core replacement * Various causes of 'no heat' problems See "Related Questions" below for links


Are there two heater cores in a windstar minivan?

If your van is equipped with the rear climate control heating/cooling option, then YES, there are two heater cores.See "Related Questions" below for more


Where would the flap be at for the heater on a 2000 windstar?

This "flap" is the temperature blend door which directs air over & through the heater core.The "Related Questions" below are intended to help explain some of the basics of Windstar heating/cooling functions and terminology.That should help in the investigation of the specific problem on the vehicle, and ultimately leading to a fix.Start with the "Where is the heater control valve located on a Ford Windstar" question and then move on to the "What could cause a Windstar to have no heat - or not be able to adjust the temperature"


When you turn on the heater the radiator fans start to the car is ford windstar 1998?

The radiator cooling fans are turned on when the heater control is set to defrost.This makes for better and more effective defrosting of the windshield


What is the p135 code for a ford windstar?

Heater circuit fault


How much coolant fluid in a 2001 windstar with rear heater?

15.0 liters ( 15.9 quarts ) according to the 2001 Ford Windstar Owner Guide - cooling system capacity with rear heater


Where is the heater control valve located on a 1997 Chrysler LHS?

It does not have a heater control valve.It does not have a heater control valve.


Is it easy too fix the heater core in a 2000 ford windstar?

no no


Can a plugged up heater hose cause a massive leak from the heater hose connector on a 2000 Ford Windstar The heater stopped working a few months agoand I've already changed the thermostat.?

A blocked heater hose could cause a leak. A stopped up heater core could as well. Or the connector in the Windstar could be cracked.


How do you change heater core on 93 Mazda protoge?

Replacement of the heater core on a 1993 Mazda Protege is going to first require the removal of the entire dashboard. Once that is removed then the heater control box will need to be removed and disassembled in order to get access to the heater core inside.