first thing you do is you remove the screw at the bottom left hand corner. then there are two screws in the door release handle and one in the handle where the heated seat button is located giving that u have a gs all screw except the one located at the bottom left corner had cap to hide them. simply pryoff the caps. once the all screws have been remove gently pull the bottom of the door panel so all the clips disengage. at the same time lift to remove the panel.....but dont forget there are about four or five conectors for the windows, power locks, foot light and heated seats. the door release is conected to a metal rod that also must be disconted but be gentle because it it is held in to place by a small pice of plastic dont break it or the rod will not stay in place when you put back on the door panel.
driver side right next to the clutch pedal, above the foot rest. very hard to work with
HOW TO REPLACE A TIMING BELT ON A 1992 ACURA VIGOR? how do you change a timing belt on a 1992 acura vigor 2.5l how do you change a timing belt on a 1992 acura vigor 2.5l -------------------------------- See article at the Acura Vigor Club -- Related Links (below).
Where is the fuel pump locate on the 1992 acura vigor
i dont kniw
1992-94Vigor6 1/2"6x9"
On a 1992 Acura Vigor idle is adjusted through a idle control valve. Tightening the valve well raise the lower the idle and loosening it will raise it.
The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.
Fuel
I am a installer movil electronics yoghurt`s sound and to disable the factory alarm in 92 Acura vigor is to take-off the drivers door panel. It a 6 o 7 wires to run from the door key cylinder grab the wire green/black and grounded that`s it.
The driver side electric window switch on a 1992 Acura Integra is reached by removing the door panel. Unbolt the switch from the mounting bracket and disconnect the wiring from the harness. Replace the unit.
I am a installer movil electronics yoghurt`s sound and to disable the factory alarm in 92 acura vigor is to take-off the drivers door panel. It a 6 o 7 wires to run from the door key cylinder grab the wire green/black and grounded that`s it.
view website www.cdplayerrepair.com/remtips/vigor_rem.htm