Using a screw driver, remove the screws and remove the clips from the door panel. Remove the panel slowly, remove any wire connections, and pull the panel off the door frame.
Read "How do you remove the interior door panel on a 2000 Pontiac Grand Am?" the answers are prettymuch perfect
Take the door panel off as it bolts on from inside the door. Go to this website. It will show how to remove the door panel and the side mirror. kwmuth.com
it is 12.1 gals
Take off all the screws on the door panel.
You do it from inside the door. Take the door panel off, roll the window up, and go to town.
if you take off the door panel there will be three studs that connect the mirror to the door
take door panel off should be screwed to door remove screws take speaker out unhook wires
You don't without breaking the door panel.
To remove the door panel on a 2000 Olds Intrigue, remove the lenses off any lights in the door. Then remove the screws holding in the light assembly. Using a screwdriver, gently pop off the clips in the corners and on the sides.
on my 2000 s-type, the drivers door panel is held on by 2 screws located in the interior door pull under the small rubber mat. remove those screws and pry the panel off. pry the panel off from each snap on position, being careful not to damage the snap mounts.
I just need to figure out how to take my door panels off my car, 2000 Mitsubishi Eclipse, so I can install some new speakers.
To access the speakers on a 2000 Malibu, you will need to remove the door panel. You also may need tools like screwdrivers and a wire cutter to take the door panel off. Before starting any removal of the panel, you should disconnect the negative battery cable.