Auto Parts and Repairs
Dodge Dakota
Ford Escort LX
MySpace

How do you take off the front left side CV axle of a 1991 Toyota Corolla 4 door?

383940

Top Answer
User Avatar
Wiki User
2004-11-22 14:10:01
2004-11-22 14:10:01

You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do u remove cv axle driverside 1991 toyota corolla

User Avatar

Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.

User Avatar

It would be easiest with an impact, but a breaker bar may work.

User Avatar

Where is the location of check ball in the valve body for Toyota Camry 2005 E250U automatic transmission please I need the sechmatic or diagram for it.?

User Avatar

It does have CV joints but, it is best to just swap out the complete axle assembly than to replace only the CV joint. You will spend much time and almost as much money trying to replace the CV joint than to just purchase a reconditioned axle assembly and swap it.

User Avatar

what size socket for front axle nut 1991 ford tempo

User Avatar

No, the frames are different. In 1986 Toyota went from a solid front axle design to independent front suspension. Therefore the frames are different.

User Avatar

if it. 4wd the wires on the front axle are for the axle diconnect to engage and disengage the 4wd. the wires on the rear axle axle are for the rear axle speed sensor. so the computer can actuate abs system

User Avatar

The actuator is located on the front axle.

User Avatar

If it is 4 wheel drive then there is a solid axle in the rear and a trans-axle in the front. the trans-axel has two CV shafts on either side connecting to the front tires. If it is 2 wheel drive then there is just a solid rear axle. and your front tires mount to spindles.

User Avatar

Get a manual from a parts store and it has pictures and all.

User Avatar

Yes it can minor grinding may be required

User Avatar

With a gas powered torch and an electric welder you can put any front axle in any vehicle ever manufactured on planet earth

User Avatar

A trans axle is a transmission and differential rolled into one in a front wheel drive vehicle. The trans axle delivers power from the engine to the drive wheels.

User Avatar

Located behind the front axle on the passenger side, best accessed from under the truck

User Avatar

Thunderbirds never had a front axle

User Avatar

A 1994 Ram 1500 has a Dana44 front axle. A 2500/3500 has a Dana60 front axle.

User Avatar

My Chilton's manual says to drop the front crossmember holding the front drive axle ! You will also need to remove the front driveline from the front drive axle ! Chilton's book #68602 !

User Avatar

The maximum weight the front axle is designed to carry.

User Avatar

A front axle holds the front wheels on and on front-wheel drive vehicles transmits engine torque to the wheels. --Ken

User Avatar

My Toyota Sienna 2000 axle nut measures 30 mm Sprayed the threads as I will be replacing an axle shortly. Probably the same size.

User Avatar

The front spindle nut on a 1991 Honda Civic requires a 32mm axle nut socket.

User Avatar

That switch is screewed into the top of the transfur case that's bolted to the rear of the transmission.

User Avatar

Yes , Maruti 800 is front axle driven car..


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.