Hold firmly and pull. It has slide clips.
the panel just snaps off
Location of fuse panel on 1996 Monte Carlo. for radio,cig.liter.
The turn signal flasher on a 2001 Monte Carlo is behind the hazard button on the instrument panel. You have to take out the instrument panel bezel to access it. I found this out through a Haynes repair manual for that car. I have to replace mine and did some research. The turn signals and hazard lights are both tied into the same flasher. Hope this helps.
It should slot #1 on the fuse panel. At least the 1996 Monte Carlo fuse was located there.
Check all of your fuse panels... under the hood and the instrument panel If you are sitting in the drivers seat it is above your left foot.
no you have to drop the gas tank
The Monte has 2 fuses for the "blinker" or flasher module. They are located in the interior fuse panel that is located on the right hand side of the instrument panel. Fuse position "30" is a 10amp fuse and fuse position "5" is a 15 amp fuse.
The 1997 Monte Carlo inside door panel is held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
The 91 Vandura G2500 Instrument Panel Cluster Relay is located on the dashboard.
instrument panel or controls?
The fuse panel is located under the left side of the dashboard.
actually there is a panel in the trunk 02 monte under the rug near the back seat
Hello, Last night I was looking for that same answer, I called the GM dealer here and they printed some very helpful info, If you will e-mail me I will send you a copy of it. Bob email@example.com
Why does a red light flashes PRG FI on the dashboard instructment panel of my 1987 Honda Civic
DAT stands forDash Automatic Transmission (Shifter is on the dashboard/instrument panel)
Begin by removing the instrument panel cover from your Mercedes-Benz E430. Push the lightbulb in and turn it at the same time. The instrument panel lightbulb will come out. Reverse the process to install your new dashboard light bulb.
The Monte uses a single flasher unit that integrates turn signal and flasher functions. It is mounted in a junction block that is attached to the firewall just to the left of the steering column under the instrument panel. To get at it you have to remove the the sound insulation panel that is attached to the lower steering cover and then the lower steering cover as well.
Changing the instrument panel lights require removal of the dashboard. With the dashboard removed pull the gauge cluster out and take off the bulbs. Install the new bulbs.
We call it a dashboard, or sometimes just dash. I guess some people may call it an instrument panel or console, but vary rare.
That is in the fuse panel inside the car. Marked I/P illum (instrument panel illumination)
Yes, in the fuse panel under the bottom of the left hands side of the dashboard.
Begin by removing the dashboard instrument panel cover. Take hold of the dashboard lightbulb, push in and turn at the same time. The dashboard lightbulb will come out. Reverse the process to install your new dashboard lightbulb.
Should be able to access after removing interior door panel
Look in your owners manual if you have it and if you don't, see the Chevy dealer parts man and have him print it out for you.
post your question on www.lexusownersclub.com they have people there who know that answer