You need to take take off 4 screws from the inside of the headlight 3 that you can see the 4 one is under the light i would take off 2 screws from the bumper on the side to get some room to play with because you cant take out the light due to harness of the light you need to unplug the driver side it is the same thing with the fourth one but on the bottom screw you need to get under the car and the 4 bolt is between the radiator and frame it is very tight so use a long rachet to take off bolt.
Head on the side right side that is it has a plug [electrical and two bolts-
i have a 1994 eclipse with a 1.8 we replaced the head gasket and timeing belt now it sputters at low rpms an the check engine light is on what could be th problem ?
If you have coolant in the oil, it will cause the rod and main bearings to fail.
This will depend on the speeds that you are going at, but the 1992 mitsubishi eclipse does get up to 540 horse power, so has pretty powerful torque as well.
There are several things that can cause your 1992 Mitsubishi Eclipse to overheat. A malfunctioning water pump or a blown head gasket should be the next things that are checked.
95 eclipse hornJust stick your head under the car beneath the bumper on the driver side in front of the tire and look up. Its dangling off a bracket slightly separate from the rest of the frame and a little offset. hope this helps
About $ 500.00 for the top and arround $ 200.00 for the head linear + Labor
It's that little hex head screw on top of the thermostat housing
Yes it can, but you will need to get the head lights along with the bumper to do this conversion. I did it my self except I did a 1997 to a 1995. Works just fine, just remember you'll need the head lights from the 95' too.
Check your head light bulb or check the fuse 10A under the hood and see if it's not blown.
On the in side of the door on the driver side of the dash just open the door and pull the panel cover off.
You have a blown head gasket or a cracked head. STOPdriving this car immediately until you have it repaired. You will destroy this engine if you continue to run it.
There is a single phillips head screw holding each light in, you remove it, the lights should come out. To get the bulb out, there should be two tabs on the back side...you twist counter clockwise (left) then pull out
The fuse box for my 1998 Eclipse Spyder is up under the dash on the left of the driver's side leg area. Look up and inside to the left with your head down by the brake pedal.
for this type of engine 1.5 the torque will be 53 f.p
It's behind the headlight.
The 2013 Mitsubishi Lancer has 39.6 in. of front head room.
The 2005 Mitsubishi Outlander has 38.9 in. of rear head room.
The 2003 Mitsubishi Outlander has 38.9 in. of front head room.
The 2011 Mitsubishi Outlander has 40.3 in. of front head room.
The 2006 Mitsubishi Outlander has 38.2 in. of rear head room.
The 2008 Mitsubishi Outlander has 40.3 in. of front head room.