Home
How do you take the dash off an '86 Ford Ranger?
Wiki User
Answered 2015-07-15 20:05:20
Start with the screws located underneath the top edge. pop off the middle molding. the hard one is the molding around the headlight pull knob. Be careful or you will break the light switch.
Your Answer
Still Have Questions?
Related Questions
How do you take the fan cluch off a 89 Ford Ranger to replace?
how do i take the fan cluch off a 89 ford ranger yo replace
How do you turn off check engine light on a 2002 Ford Ranger?
Take your 2002 Ford Ranger to the garage to get the engine checked.
Is there an on and off switch for the airbag in a Ford Ranger?
The on/off switch, located on the lower side of the dash, below the radio, is for the passenger side only.
Where is the Location of fuel pump shut off switch for an 1989 ford ranger?
it should be under the drivers side dash
What fuse is for the blinkers on a 1990 Ford Ranger?
In the fuse box. Take the bolts and wiring loose from the rear fo the radio under the dash. Then pull off the knobs and remove the nuts under there and work it out .
How do I Take courtesy lamp cover off on a 1997 ford ranger?
Squeeze in on the sides and snap it out.
How do you turn off the seatbelt chime on a ford ranger 2003?
If you connect you seatbelt for about a minute or two, then take it off, it should shut off.
How do you take the fan off a ford 4.0 ranger to get to the water pump?
counter clock wise will remove the fan
Where is the fuel pump on a 1989 ford ranger?
it is in the tank you have to take the bed off or drop the tank it is in the top of the tank
Where is the emergency fuel shut off on a 94 ford ranger?
yes, it is usaly be hind pass.side kick panel or under were the caret ends under dash on pass.side
Where is the fuel cut off switch in ford ranger 1997?
I believe that is in the right front passenger footwell , above the carpet and below the dash , in the right hand corner
How do you know if your 2001 ford ranger is in theft mode?
its always in theft mode. There should be a little light that will flash on the dash or around the speedometer when the ignition is off and the key is out.
How can you shut of your anti theft alarm on your 2003 Ford Ranger?
How can you shut off your anti theft alarm on a 2003 Ford Ranger
How do you change heater core on 99 ranger?
take it to a shop because the WHOLE dash has to come off and then some more that is why is costs $800.00
How do you remove the center console on a 2005 ford explorer?
You have to take off the whole dash board to get to the center console!
How do you measure the rear brake drums in a 1992 Ford Ranger?
Take them off and measure the machined surface for width and the diameter.
Where is the regulator located on a 1993 ford ranger 4.0 engine?
The voltage regulator is on the alternator, you'll have to take the alternator off to get at it.
How do you get into front turn signal bulb housing on a 02 Ford Ranger?
Take off the front grill and then remove the housing
Can you use a drivers side door off of a 1983-1987 ford ranger on a 1984 Ford Ranger?
Yes, they should swap out. As long as the cab style is the same, then the 1983-1987 Ford ranger doors will fit a 1984 Ranger.
Where is the emergency shut off switch for a 1996' ford ranger?
I believe it is in the right front passenger footwell , on the right side , between the carpet and the dash ( fuel pump shut off / inertia switch )
Why is my your Ford Ranger overheating?
Is not getting water to cool it off.
How do you replace an ignition switch 1984 ford ranger?
take the steering wheel off and take the ignition lead off and then you buy a new ignition with new key or vis versa
1990 Ford Ranger manual?
A person can get a 1990 Ford Ranger manual directly from the Ford company. You can visit a dealership near you and they can order the manual or print one off for you.
Will a door off a 1994 ranger fit a 2000 ford ranger?
No. Completely different body styles.
Well a reese hitch off Ford Ranger 2003 fit 2002 windstar van?
The Ford Ranger and Ford Windstar were produced on two totally different chassis. This makes putting a hitch from a Ranger onto a Windstar a structuraly problem. If you know how to weld pieces onto or cut pieces off of the hitch, there is always a way to make the hitch work. If, however, you want to just take the hitch off of the Ranger and bolt it up the Windstar, that would never work.
Still have questions?
