Driver Side Window Regulator Assembly replace on 2004 pontiac grand prix
change the window regulator
You will have to replace the regulator assembly.
Look behind the CD player in the dash
turn bolts to the left, install regulator, turn bolts to the right
No. In fact, the wires from the rear if connected to the front will fix a 250 problem!
Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly
First you need to remove the door panel.Then remove the door handle bracket.Peel back the moisture shield.Tape the window into place,then unbolt the window from the regulator.Remove the window regulator from the access hole in the door.
The window motor is attached to the window regulator by screws. After removing the door trim you must detach the regulator from the door by drilling-out four rivits. Then remove the screws from the old motor and install the new motor. Re-attach the regulator with bolts and put the trim back on the door.
u have to have the window rolled down about 4 inches. If the window is stuck up force it down and you can access 2 bolts holding it to the window. Only force it if you plan to replace the regulator.
It could be the window regulator. If it is worn out and binding, it could cause the window to move slowly, jerkily, or not at all.
what is a window regulator on a 01 vw jetta
First, lower window approximately half way. This allows you access to the bolts that attach window to the regulator. Remove door panel. Using a 10mm wrench, remove the two bolts that hold window to the regulator. Then there are two upper and two lower bolts holding the regulator to the door. Then you remove the three bolts for the window motor which is toward the front of the door. You have to also disconnect the plug for the windo motor to remove the entire window regulator and motr that are all one unit. Replace the unit in the reverse way.
window regulator cable is broken need new regulator
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
need to know how cables connect on window regulator
To remove the window regulator in your 2005 Dodge Stratus, you would need to remove the door panel, and then the water shield behind the door panel. Tape the window into the up position with tape, and then you can access all of the nuts and bolts to remove the window regulator. I have included a link below to an instuctional video that will show you how to do this on a 01-06 Dodge Stratus.
if manual, window regulator. if electric, check fuses, window switch, window motor, window regulator.
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.
You can use a bolt and lock nut, probably 1/4 inch.
Which regulator and what year? You have a window regulator, voltage regulator, fuel pressure regulator to name a few.
To remove the drivers side window and regulator, you will need to remove the door panel from the door. Then you can unbolt the regulator and window to remove them.
probably window regulator
Try this link, http://www.a1electric.com/grandam.htm. It shows how to replace the entire window regulator assembly (which includes the motor). Probably the cleanest description I have found.
u have to remove the drivers window and remove the regulator assy...once its out there ar 4 rivits u have to drill out be very carefull of th spring in the regulator it will come out and injure u if u don't take the proper precautions