Dodge Caravan
Ford Escape XLT
Ford Ranger XLT

How do you take the motor out of a 1987 Dodge Caravan front wheel drive?

545556

Top Answer
User Avatar
Wiki User
2015-07-16 19:18:25
2015-07-16 19:18:25

It's been a while but you need to drop the whole front end out. Frame, motor and tranny. You will need to pull the drive shafts out on both sides. Disconnect everything from the engine and transmission and than unbolt the frame assembly. Lower the assembly, you may also need to raise the body to clear it out.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Front of the block, behind the motor mount.

User Avatar

Front of the engine, behind the motor mount.

User Avatar

It is on the front of the engine, behind the motor mount bracket.

User Avatar

The Dodge Intrepid was always front wheel drive.

User Avatar

how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?

User Avatar

It is over the right front strut tower, accessible under the hood.

User Avatar

The fuel pump on a Dodge Caravan is not on the motor, it's located inside the fuel tank.

User Avatar

Yes and no, you'll need to replace the computer,trans,motor mounts,front exhaust pipe and possibly the wiring harness, not a job for the inexperienced

User Avatar

The resister is right behind the glove box.

User Avatar

The starter is located under the front drivers side of the motor next to the Transmission. It can be found by the motor mount.

User Avatar

Behind the fuse box underneath the steering column.

User Avatar

No, unless you want to destroy your transmission (the Caravan's). The front wheels must be dollied if it's front wheel drive, and it must be trailered if it's all wheel drive.

User Avatar

Behind the glove compartment.

User Avatar

On a 2000 Dodge Caravan, the wiper motor is located under the hood on the passenger side of the engine compartment. It is found over the strut tower in the firewall.

User Avatar

I forgot to add that the motor in this 94 Dodge Grand Caravan ES is a 3.3L

User Avatar

It would bolt in, but will not run. The tone rings for the camshaft and crankshaft position sensors are different.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.