There is no governor, The ecm/ computer controls the speed limiter.
you have to have the computer reprogrammed to get rid of the speed sensor or governor as you call it.
It does not have a governor. Speed is computer controlled, by either a rev limiter or fuel shutoff.
you have to have the computer reprogrammed to get rid of the speed sensor or governor as you call it. just buy a hypertech programmer and you can fix it. they cost 300.00
It does not have a removable governor. Speed is computer controlled by the ECU.
You do not have a governor, you have a Rev Limiter. At a preset RPM the computer cuts back on the fuel supply. The computer will have to be reprogrammed. yes you have to buy a programmer and set the speed rateing for your tires and it will go up to 200
It has no governor. Speed is controlled by the ECU.
Take out the governor
The so called governor is a rev limiter that is part of the computer and can not be replaced. You may find someone to reprogam it.
You can't as it has no governor. Speed is controlled by the ECU.
It requires a visit to a programmer. Voids the warranty though.
yes u can
Maybe take a look at "SLD (Speed Limit Defencer)" by HKS
No. There are always problems with engine swaps. It depends on how much you are willing to take on. However, this would be a relatively easy swap.
You can't as it has no governor. Speed is computer controlled. ANSWER get yourself one those handheld programmers (i have a hypertech). you can remove the top speed limiter using that.
Very simple, take out the 21 scews on the bottom of the dash pading and the panel will lift off.
Look on the passenger side of the tranny for a plug and if you take the plug out it goes in there.
For the front speakers you need to take off the dash pad and the rear speakers you need to take off the rear speaker panels.
dont take the governor off instead use liquid nos just put a shot in your gas tank Adding nos wont do anything but maybe improve accel. The problem with the pocket bikes is that the speed governor is set low and cuts out your engine at a certain speed.
You can adjust it, by turning out the "Engine Governor Speed Adjustment" Screw. Check out the doodlebug manual, or message me for more details.
YOu take apart the engine and near the headers is a box inside the box is the governer
If you are having problems with the engine, take the scooter in for repairs. Since it is a late model, I would think it is still under warranty. If you are wanting to remove the governor to get higher rpm's and more speed, DON'T DO IT. The governor plays an important part in maintaining the engine at optimum performance by governing maximum speed. If you remove the governor, you will be risking serious damage to the engine due to uncontrolled overspeeding.
200kph or 120 mph
what type engine oil does a 92' Chevy camaro rs v6 take what type engine oil does a 92' Chevy camaro rs v6 take
The speed limiter program is located in the ECU. Some companies make "boxes" to fool the ECU. Otherwise, unplug the speed sensor, and use a portable GPS to measure speed.