Sepentine-replace tensioner,v-belt, adjust accessory and tighten.
there is a belt tensioner pulley that maybe is not working correctly
You can do that by replacing the tensioner
the belt is automatically tensioned by a spring loaded tensioner.
The belt has an automatic spring tensioner and can not be "tightened".
this question should be under dodge automobiles
look in the instruction booklet
Its a lap belt.
Tighten it or replace it.
The alternator will move in and out to tighten the belt and the PS pump will do the same
Should be done automatically by the belt tensioner unless tensioner is weak or bad
replace the spring loaded belt tensioner as it's the only thing that will keep the serpentine belt tight.
The fan is electric, not belt driven. The serpentine belt is has a spring loaded tensioner. If the belt is loose, the tensioner has failed.
The belt tensioner is self-adjusting.
If it's the alternator belt, loosen the bolts holding the alternator in place, then use something like a hammer handle to pry the alternator away from the engine which will tighten the belt. Hold the pressure on the alternator while tightening the bolts. This is a general procedure, not specific to 1996 dodge.
it should automaticly tighten when you release the tensioner pulley after putting the new belt on. if it does not tighten 1 of 2 things happened 1). you didnt run the belt the right way 2). tensioner assembly is faulted and needs to be replaced.
The belt on a 2000 Ram uses a spring loaded tensioner pulley. It self tightens.
Replace or tighten the A/C belt. If equipped with a serpentine belt, replace it.
You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
First and foremost, make sure you have a diagram before removing the old belt. If there isn
Loose or worn A/C drive belt. Tighten or replace. If serpentine belt, replace.
you dont belt is self adjusting one of the puleys is called a tenteder belt or tenteder may need repacleing
how do you tighten fan belt on l200